Nanomanufacturing - Reliability assessment - Part 3-4: Linearity of output characteristics for metal contacted 2D semiconductor devices
Introduction: Atomically thin two dimensional (2D) nano-materials are expected to be used for future electrical sub-systems or electronic device applications. I-V measurements are the fundamental electrical characterization technique for assessing reliability of field-effect transistors (FETs) as well as semiconductor device performance. The performance of the FET is mainly characterized by measuring the output (drain current as a function of drain voltage at different gate voltages) and transfer (drain current as a function of gate voltage at different drain voltages) characteristics. If metallic electrical contacts have negligible effects on electronic transport, output characteristics show linear behaviour according to the following formula: ox th μ WC , where Id is the drain current, μn is the electron mobility, W is the transport channel width, Cox is the gate oxide capacitance, Vg is the gate voltage, Vth is the threshold voltage, and Vd is the drain voltage, which can indicate ohmic contact. In contrast, when metallic contact gives rise to high resistance to electronic transport, output characteristics do not show the linear behaviour, following the formula: )( ox th μ WC [1] where Rc is the contact resistance, which is interpreted as Schottky contact which can bring about a reliability issue of ohmic-contact semiconductor transistor operation. Current transport at the metallic contact of 2D semiconductor material-based FETs mainly consists of two distinct components: thermal emi
Scope: This part of IEC 62876 establishes a standardized guideline to assess reliability of metallic interfaces of ohmic-contacted field-effect transistors (FETs) using 2D nano-materials by quantifying linearity of current-voltage (I-V) output curves for devices with various materials combinations of van der Waals (vdW) interfaces. For metallic interfaces with 2D materials (eg. graphene, MoS2, MoTe2, WS2, WSe2, etc) and metals (eg. Ti, Cr, Au, Pd, In, Sb, etc), the reliability of ohmic contact is quantified. For FETs consisting of 2D materials-based channels (eg. MoS2, MoTe2, WS2, WSe2, etc), the reliability of ohmic contact when varying contacting metal, channel length, channel thickness, applied voltage, and surface treatment condition is quantified. The reliability of the metallic contacts is quantified from the linearity of I-V characteristics measured over extended time periods.
Contents:
- FOREWORD
- INTRODUCTION
- Scope