General requirements for lighting systems – Safety
Introduction: Lighting systems are becoming more common, not only to save energy but also to improve human well-being. These systems are often comprised of many different products (luminaires, sensors, controllers, touch panels and other human interfaces, etc.) which are connected through communication cabling or wirelessly, where the light output can be varied based on the input from sensors or users. This safety document is intended to cover those safety aspects that are specific to a lighting system and are not covered by existing standards. This document does not address safety aspects that are already covered in: product safety standards, installation safety standards. IEC Guide 110 gives guidance on determining which electrical safety aspects of systems should be covered. Products that are considered safe, according to the relevant product safety standard, need to remain safe when connected to a network. The products need to remain safe under normal, abnormal and single fault conditions of any product connected to the lighting network. For this purpose, the following electrical safety aspects are mentioned in IEC Guide 110: 1) protection from overvoltages on the network; 2) protection from hazards caused by connection of different types of circuits; 3) limitation of network interface leakage current; 4) protection from overheating of the communication network. By correctly classifying a network, and by applying the required electrical insulation between different types of circuits, a
Scope: This document specifies the safety requirements of lighting systems at the system level, applicable when designing a lighting system. A lighting system comprises a set of products. Safety requirements of the products are not covered in this document, but specified in product safety standards. NOTE For emergency lighting systems, national or regional regulations provide relevant information that can be firstly consulted. This document specifies safety requirements for lighting systems based on specific networks. This document does not cover cyber-security and information security of lighting systems. This document does not apply to lighting systems to be installed in potential explosive atmospheres which are under the scope of IEC TC 31. For lighting systems based on an information and communication technology (ICT) network, refer to IEC 62949. For lighting systems based on a home and building electronic system and building automation and control system (HBES/BACS) network, refer to IEC 63044-3.
Contents:
- FOREWORD
- INTRODUCTION
- Scope