IEC System for Conformity Testing and Certification of Wind Turbines; Rules and Procedures
Introduction: NOTE This INTRODUCTION provides an overview of the IEC WT System and is not part of the Rules. The international scheme for recognition of results of testing to standards for wind turbines is operated by the IEC, and known as the IEC WT System. The IEC WT System is based on the principle of mutual recognition (reciprocal acceptance) by participants of test results and certificates issued by other participants for obtaining certification at national level, and operates within the scope of the IEC 61400 series of standards for wind turbines. In addition to type testing, the IEC WT System provides for the recognition of or assessment for approval of the manufacturer's quality system, regular surveillance through inspection of the manufacturer's factory quality system and product quality plans, and audit testing of samples from the manufacturer's factory. The System is intended to result in significant benefit to the manufacturer by reducing the number of steps necessary to obtain certification or approval at national level.
Scope: This publication defines a certification system for wind turbines (IEC WT). It specifies rules for procedures and management to carry out conformity evaluation of WTs, with respect to specific standards and other technical requirements, relating to safety, reliability, performance, testing and interaction with electrical power networks. It provides: definitions of the elements in a wind turbine certification process; procedures for the conformity evaluation in a wind turbine certification system; procedures for conformity surveillance; rules for the documentation that is to be supplied by an Applicant for the conformity evaluation; and requirements for certification and inspection bodies and testing laboratories. – 8 – IEC WT 01 IEC:2001(E) The standard is not limited to WTs of any particular size or type. It describes procedures relating to design, manufacture, erection and installation, operation and maintenance, and decommissioning. The procedures deal with the assessment of loads and safety, testing, characteristics measurements and surveillance of manufacturing, installation and operation. Some elements of certification are mandatory, whilst provision is specifically made for others to be optional. The purpose of the standard is to provide a common basis for certification of wind turbines, including a basis for acceptance of operating bodies and mutual recognition of certificates. The standard shall be used in conjunction with the appropriate IEC/ISO standards and Guides, see clause 6. References The following documents contain normative provisions, which, through reference in this text, constitute provisions of the International Standard. At the time of publication, the editions indicated were valid. All normative documents are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents referenced below. Members of IEC and ISO maintain registers of currently valid International Standards. IEC 61400-1: (Ed. 2, 1999), Wind turbine generator systems. Safety requirements. IEC 61400-2:1996, Wind turbine generator systems. Safet
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 10.1 General
- 10.2 Agreement on Certification
- 10.3 Issue of Certificates and Conformity Statements
- 10.4 Security of Relevant Documentation
- 10.5 Maintenance and Expiration of Certificates
- 10.6 Corrective Actions
- 11.1 General
- 11.2 Type Certification
- 11.3 Project Certification
- 11.4 Component Certification
- 12.1 General
- 12.2 Design Evaluation
- 12.2.1 Design Control
- 12.2.2 Control and Protection System
- 12.2.3 Loads and Load Cases
- 12.2.4 Structural, Mechanical and Electrical Components
- 12.2.5 Component Tests
- 12.2.6 Foundation Design Requirements
- 12.2.7 Manufacturing Plan
- 12.2.8 Installation Plan
- 12.2.9 Maintenance Plan