Zhaga interface specification Book 1 and Book 10
Introduction: This PAS is a reproduction of Zhaga Book 1 Edition 1.8 and Book 10 Edition 1.0 with no changes introduced. The document layout, terms and definitions, etc within this PAS therefore do not follow the normal IEC drafting rules that would be applied for an International Standard. Subdivision 1 comprises Zhaga Book 10 Edition 1.0 – Circular LED modules for spot lighting. Subdivision 2 comprises Zhaga Book 1 Edition 1.8 – Overview and common information, which is essential to the interpretation of Zhaga Book 10 (and future Zhaga books). The future intention is for the content of this PAS to be incorporated within one or more International Standards and at this time any conflict with IEC Directives and drafting rules will be addressed.
Scope: This Book 10 defines interfaces between LED Modules, associate components (Holders) and luminaires. Not all interface descriptions are applicable to LED Modules or Holders, but where applicable they are identical. The scope of the interface descriptions is focused on a range of LED Modules with a circular shape and high luminance LES. A LED Module is intended to be fixed to a luminaire heat sink by means of screws. Its light output distribution is primarily Lambertian, to enable Luminaire Optics to shape an application-specific light distribution independently of that of the LED Module. Zhaga Book 12 defines an LED (Chip on Board) Array component, which shares certain interface descriptions with this Book 10 (mainly photometric). It is possible to combine a Book 12 compliant LED Array with a Holder that ensures mechanical and electrical fit of the assembly. The Holder provides its own set of mechanical/electrical/thermal interfaces to a luminaire. If these interfaces are compliant with the interface descriptions in this Book 10, the Holder+LED Array assembly can be used in the same way as an LED Module compliant with this Book. Thus this Book can also be used to check compliance of Holders with respect to the Holder-Luminaire interface. This Book 10 defines several size categories of the LED Module 35 mm, 50 mm maximum outer diameter The size categories can have different LES diameters and different LES categories: LES6.3, LES9, LES13.5, LES19, LES23 The LED Modules are intended to be installed and replaced by professionals only. 1.3 Conformance and references 1.3.1 Conformance All provisions in the Zhaga interface Specifications are mandatory, unless specifically indicated as recommended, optional or informative. Verbal expressions of provisions in the Zhaga interface specifications follow the rules provided in Clause 7 of ISO/IEC Directives, Part 2:2018. For clarity, the word “shall” indicates a requirement that is to be followed strictly in order to conform to the Zhaga interface specifications, and from which no deviation is permitted. The word “should” indicates that among several possibilities one is recommended as particularly suitable, without mentioning
Contents:
- FOREWORD
- INTRODUCTION
- Introduction
- Scope