IEC TR 60286-3-4-2021 PDF

IEC TR 60286-3-4-2021 PDF

Packaging of components for automatic handling-Part 3-4: Packaging of surface mount components on continuous embossed tapes for Auto Loading Feeder

$132.41 $264.81 -50%
Product Code: IEC TR 60286-3-4
Stock In Stock
Edition: 1.0
Published: 10/2021
Number of Pages: 30
File Size: 0 files

Available Options

Product Description

Packaging of components for automatic handling – Part 3-4: Packaging of surface mount components on continuous embossed tapes for Auto Loading Feeder

Introduction: This Technical Report was developed by the technical committee 40 working group 36 on components packaging, in which the members, such as mounter manufacturers, component manufacturers and packaging material manufacturers, had proposed, considered and discussed the possible standardization of the application of Auto Loading Feeder to enable automatically exchange SMD continuous tapes, using paper carrier tape during mounter operation, aiming to support IEC 60286-3, Edition 6, issued in 2019. This document includes data expressed in the form of provisions, such as requirements or recommendations. These data, however, do not claim to be provisions and are just suggested as the results of the discussion. The International Electrotechnical Commission (IEC) draws attention to the fact that it is claimed that compliance with this document may involve the use of a trademark concerning Auto Loading Feeder given in 3.1.1. Trademark ... AUTO LOADING FEEDER™ Trademark registration number ... No.5983611 (Japan) IEC takes no position concerning the evidence, validity and scope of this trademark right. The holder of this trademark right has assured the IEC that he/she is willing to negotiate licences under reasonable and non-discriminatory terms and conditions with applicants throughout the world. In this respect, the statement of the holder of this trademark right is registered with IEC. Information may be obtained from: Name of holder of trademark right ... Yamaha Motor Co., Ltd. Address

Scope: This part of IEC 60286 considers the proposed requirements for emboss taping for the Auto Loading Feeder mechanism to mount electric components without leads or with stump type leads used for electric circuits. This document is applicable to the embossed carrier tape, with single round sprocket holes, with tape pitches of 2 mm or more (nominal tape width: 8 mm only) among the tapes of Type 2a in IEC 60286-3.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 60286-3-4-2021 PDF

IEC TR 60286-3-4-2021 PDF

$132.41 $264.81