IEC TR 60695-2-22-2026 PDF

IEC TR 60695-2-22-2026 PDF

Fire hazard testing - Part 2-22: Glowing/hot-wire based test methods - Results of the round robin tests for the development of IEC TS 60695-2-21:2023

$255.36 $510.71 -50%
Product Code: IEC TR 60695-2-22
Stock In Stock
Edition: 1.0
Published: 03/2026
Number of Pages: 120
File Size: 1 file, 7 Bytes

Available Options

Product Description

Fire hazard testing - Part 2-22: Glowing/hot-wire based test methods - Results of the round robin tests for the development of IEC TS 60695-2-21:2023

Introduction: Fires may create hazards to life and property as a result of the generation of heat (emission of heat on fire hazard), and as a result of the production of toxic effluent, corrosive effluent, and smoke (fire effluents on the fire hazard). Fires start with ignition and then can grow, leading in some cases to flash-over and a fully developed fire. Resistance to ignition is therefore one of the most important parameters of a material to be considered in the assessment of a fire hazard. Most current fire hazard assessment techniques evaluate the resistance to ignition characteristics of a single material or component. These assessment techniques are able to drive the preselection and validation of materials and components but are not able to evaluate the possible interaction of materials or components in a complex environment such as in a finished unit once a fire event is initiated. In a fault condition, a finished unit may be subject to the overheating of electrical connections and contacts. Such overheating can be caused by corrosion, poor crimp connections, incorrect assembly, erosion of contact surfaces, or mechanical fatigue. Insulating materials that are overheated can ignite and cause fire. It is difficult to simulate the actual conditions of potential faults in finished units; therefore, all possible fire hazards should be considered at the design stage and subsequently during the preselection of materials and components. The fire containment test described in IEC TS 606

Scope: This part of the IEC 60695 series, which is a Technical Report, summarizes the round robin tests performed by the IEC/TC 89/PT 60695-2-15, "Fire containment test on finished units" during the development of IEC TS 60695-2-21:2023 [1], Fire containment test on finished units. This document aims to serve as knowledge retention, describing the methodologies, investigation, and verification techniques, as well as providing a compendium of the different verification results, of the development of IEC TS 60695-2-21:2023 [1] as new test method. IEC/TC 89 and other IEC Technical Committees can benefit from this document, when developing new test methodologies or planning and executing round robin tests.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 60695-2-22-2026 PDF

IEC TR 60695-2-22-2026 PDF

$255.36 $510.71