IEC TR 61340-2-2-2000 PDF

IEC TR 61340-2-2-2000 PDF

Electrostatics - Part 2-2: Measurement Methods - Measurement of Chargeability

$50.44 $100.88 -50%
Product Code: IEC TR 61340-2-2
Stock In Stock
Edition: 1.0
Published: 07/2000
Number of Pages: 40
File Size: 1 file, 204 Bytes

Available Options

Product Description

Electrostatics - Part 2-2: Measurement Methods - Measurement of Chargeability

Scope: This technical report describes the equipment, arrangements and procedures for measurement of electrostatic charge caused by contact and relative motion between materials and presents examples of model experiments to simulate practical processes. 1.2 Reference document IEC 61340-4-1, Electrostatics – Standard test methods for specific applications – Electrostatic behaviour of floor coverings and installed floors Fields of application Charge is generated on contact between materials of differing electronic or ionic nature. Charge is subsequently retained on breaking the contact and separation of the surfaces if at least one of the materials is an electrical insulator or isolated conductor. In general, relative motion or rubbing is unavoidable in most practical contact and separation events, the effect of rubbing being to increase real contact area and local heating. Excessive increase in temperature can influence the charging process and ultimately, of course, material transfer can occur between violently abraded surfaces. The polarity of the charge is governed by the relative electronic properties (work function) of the contacting surfaces. In most practical situations, however, the magnitude of the retained charge is limited by electrical breakdown of the medium between the separating surfaces. Despite contact charging being greatly influenced by surface contamination, surface temperature and local electric fields, the charge produced on a material in a continuously operating plant, under reasonably constant environmental conditions, can be fairly consistent in both magnitude and polarity. Ideally, the measurements using the methods described in clause 4 should be made on the actual practical system. The test arrangements described here are intended as essentially illustrative but can be used to estimate chargeability if measurements on the real plant are not possible. This technical report describes appropriate test methods for the estimation of charge generation when materials are rubbed, rub or flow on other materials. Typical practical charge generating situations include: a) semiconductor devices sliding out of shipping tubes and devices and kitted circuit

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 61340-2-2-2000 PDF

IEC TR 61340-2-2-2000 PDF

$50.44 $100.88