Low-voltage switchgear and controlgear assemblies – Part 0: Guidance to specifying assemblies
Introduction: Low-voltage assemblies form an integral part of most electrical distribution networks. In their application they have two prime functions: to safely control and distribute electrical energy; and to safely isolate sections of faulted networks. Whilst these two functions place very different demands on the assembly, an assembly has to be capable of performing both these functions throughout its expected service life. Controlling and distributing electrical energy is the assembly’s routine ongoing duty. The second function, fault management, is a very rare occurrence within a well-managed and maintained system. Some assemblies will never be called upon to manage a fault, but if a fault does occur, it can place immense thermal and mechanical stresses on the assembly in an instant. Any ageing or deterioration of the assembly should be limited such that its safety function is not impaired. Due to the nature of the application, if there are weaknesses in the design or application of an assembly, it is possible they will not be identified until years after the assembly was installed. In order to avoid latent issues, and to ensure that assemblies are suitable for their application, they will be designed and verified to meet the exacting requirements defined in the IEC 61439 series of standards. However, as the IEC 61439 series covers a wide range of applications, and some applications can be partially outside the scope of the standard, it is equally important that assemblies are corre
Scope: Within the IEC 61439 series of standards for low-voltage switchgear and controlgear assemblies, there are system and application details that are specified by the specifier to enable the manufacturer to produce an assembly that meets the needs and expectations of the specifier. This part of IEC 61439, which is a technical report, identifies from the specifier’s perspective those functions and characteristics that are defined when specifying assemblies. It provides: an explanation of the assembly characteristics and options within the IEC 61439 series; a guidance on how to select the appropriate options and define characteristics so as to meet specific application needs; and an assistance in the specification of assemblies. References within this document to the interface characteristics of an assembly and the requirements with which they will comply assume that the assembly is designed, manufactured, and verified in accordance with the relevant part of the IEC 61439 series.
Contents:
- FOREWORD
- INTRODUCTION
- Scope