Equipment for general lighting purposes – EMC immunity requirements – Part 1: Objective light flickermeter and voltage fluctuation immunity test method
Introduction: The fast rate at which solid state light (SSL) sources can change their intensity is one of the main drivers behind the revolution in the lighting world and applications of lighting. Linked to the fast rate of the intensity change is a direct transfer of the modulation of the driving current, both intended and unintended, to a modulation of the luminous output. This light modulation can give rise to changes in the perception of the environment. While in some very specific entertainment, scientific or industrial applications a change of perception due to light modulation is desired, for most everyday applications and activities the change is detrimental and undesired. The general term used for These changes in the perception of the environment is are called "temporal light artefacts" (TLAs) and can have a large influence on the judgment of the light quality. Moreover, the visible modulation of light can lead to a decrease in performance, increased fatigue as well as acute health problems like epileptic seizures and migraine episodes [17][18]1. Different terms exist to describe the different types of TLAs that may be perceived by humans. The term "flicker" refers to light variation that may be directly perceived by an observer. "Stroboscopic effect" is an effect which may become visible for an observer when a moving or rotating object is illuminated (CIE TN 006:2016 [26]). Possible causes for light modulation of lighting equipment that may give rise to flicker or stroboscopic e
Scope: This part of IEC 61547 describes an objective light flickermeter, which can be applied for, amongst others, the following purposes: testing the intrinsic performance of all lighting equipment without voltage fluctuations; testing the immunity performance of lighting equipment against (unintentional) voltage fluctuation disturbance on the AC power port; testing the immunity performance of lighting equipment against intentional voltage fluctuation on the AC power port arising for example from ripple control systems. measuring the intrinsic performance of all lighting equipment without the application of voltage fluctuations in terms of illuminance flicker; during this measurement, the lighting equipment is supplied with a stable mains; testing the immunity performance of lighting equipment against (unintentional) voltage fluctuation disturbance on the AC mains in terms of illuminance flicker; during this test a set of defined voltage fluctuations are applied to the AC mains and the immunity of the lighting equipment to the disturbance is determined. Apart from the above two purposes, the immunity performance of lighting equipment can also be tested against intentional voltage fluctuation on the AC mains arising for example from mains signalling. This is however not described in further detail in this document. NOTE 1 IEC 61000-4-13:2015 [24] provides guidance regarding test levels and frequencies for mains signalling. The object of this document is to establish a common and objective reference for evaluating the performance of lighting equipment in terms of illuminance flicker. Temporal changes in the colour of light (chromatic flicker) are not considered in this test. This method can be applied to lighting equipment which is within the scope of IEC technical committee 34, such as lamps and luminaires, intended for connection to a low voltage electricity supply. Independent auxiliaries such as drivers can also be tested by application of a representative light source to that auxiliary. The objective light flickermeter and voltage fluctuation immunity method described in this document are based on the IEC 61000-3-3 standard for voltage fluctuation limits and the fl
Contents:
- FOREWORD
- INTRODUCTION
- Scope