IEC TR 62039-2021 PDF

IEC TR 62039-2021 PDF

Selection guidelines for polymeric materials for outdoor use under HV stress

$132.41 $264.81 -50%
Product Code: IEC TR 62039
Stock In Stock
Edition: 2.0
Published: 08/2021
Number of Pages: 34
File Size: 1 file, 1 Byte

Available Options

Product Description

Selection guidelines for polymeric materials for outdoor use under HV stress

Introduction: There is a need within utilities and industry for material standards that define the physical properties of the polymers applied for outdoor insulation. This requirement was identified during discussions in IEC TC 36 and IEC TC 112. As a consequence, in 2001, CIGRE formed the working group D1.14 and later on working groups D1.27, C4.303 and D1.58 with the specific task of defining the physical parameters which are important for the polymeric materials applied in outdoor insulation and developing the relevant test methods, where necessary. As a first step, a state-of-the-art report was issued by CIGRE in Technical Brochure 255. Thirteen properties were identified; standardized test methods and minimum requirements were available for eleven of them. For the remaining property of hydrophobicity retention and recovery, test methods and minimum requirements still need to be defined. This will be the future task of SC D1. This document presents, as a conclusion of the CIGRE report, the important material properties for polymeric materials used in outdoor insulation, where they are applicable, and lists standardized test methods including minimum requirements. If no standardized tests are available, then test methods reported in literature (references in the bibliography) are summarized.

Scope: This document presents the important material properties of polymeric materials used in outdoor insulation and, where applicable, lists standardized test methods including minimum requirements. If no standardized tests are available, the test methods reported in literature are summarized. This document is valid for insulating materials having polymeric insulation, which are used in outdoor high voltage electrical applications with a system voltage greater than 1 000 V AC and 1 500 V DC (several tests are only defined for alternating current, which are not applicable for direct current). Such applications are relevant where the housing is an integral part of the device, for example in surge arresters and cable terminations. The scope of this document is limited to the insulation materials only and is not generally intended for coating materials (coating materials are, for example, thin layers applied on toughened glass and ceramic). Some tests mentioned in this document are applicable for coating and are under consideration by CIGRE. The performance of insulators in service depends on several factors such as the type of material, the design and environmental conditions. Consequently, the choice of materials that fulfil the requirements listed in Table 1 is a necessary condition but does not guarantee satisfactory performance when used in outdoor insulation. In Annex A and Annex B different test methods for testing additional properties are given, which are not standardized.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 62039-2021 PDF

IEC TR 62039-2021 PDF

$132.41 $264.81