IEC TR 62131-1-2011 PDF

IEC TR 62131-1-2011 PDF

Environmental conditions-Vibration and shock of electrotechnical equipment-Part 1: Process for validation of dynamic data

$15.77 $31.53 -50%
Product Code: IEC TR 62131-1
Stock In Stock
Edition: 1.0
Published: 02/2011
Number of Pages: 12
File Size: 1 file, 208 Bytes

Available Options

Product Description

Environmental conditions – Vibration and shock of electrotechnical equipment – Part 1: Process for validation of dynamic data

Introduction: A major reservation, identified early in the work of IEC technical committee 104 (working group 15) to collate dynamic environmental data, was the lack of fully validated data sets. In the absence of fully validated dynamic information, an essentially empirical data validation procedure has had to be adopted. The process set out in this technical report is intended to be generic in nature and is normally expected to be adopted as far as is practical within the circumstances of any particular data item. In most cases, a fully quantified validation approach is not possible; as a consequence, the alternative approach set out in this technical report has been adopted. The approach is fundamentally an exercise in building confidence that the data were acquired and analysed in a competent manner. Such confidence is essential if the data is to form a reasonable basis for establishing trends and quantifying environmental conditions. A fundamental consequence of the absence of fully validated data sets is that no single data set can be entirely relied upon to quantify any dynamic environmental condition. As will be seen, a minimum of three independent data sets are required to complete the third phase of the verification process. All of these data sets should have met the preceding two data verification phases. The validation process is set out in three phases. The intent is that each phase builds on the one preceding it and are normally undertaken in the order indicated. The data are

Scope: IEC/TR 62131-1, which is a technical report, reviews the essentially empirical data validation procedure adopted to establish confidence in the data utilized by the other Parts of IEC/TR 62131. The adoption of a validation procedure was necessary, due the lack of fully validated data sets. This technical report is intended to be generic in nature and is normally expected to be adopted as far as is practical within the circumstances of any particular data item.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 62131-1-2011 PDF

IEC TR 62131-1-2011 PDF

$15.77 $31.53