IEC TR 62482-2008 PDF

IEC TR 62482-2008 PDF

Electrical installations in ships-Electromagnetic compatibility-Optimising of cable installations on ships-Testing method of routing distance

$50.44 $100.88 -50%
Product Code: IEC TR 62482
Stock In Stock
Edition: 1.0
Published: 02/2008
Number of Pages: 20
File Size: 1 file, 1 Byte

Available Options

Product Description

Electrical installations in ships – Electromagnetic compatibility – Optimising of cable installations on ships – Testing method of routing distance

Introduction: In accordance with IMO-Resolution A.694/6.1: “All reasonable and practicable steps shall be taken to ensure electromagnetic compatibility between the equipment concerned and other radio communication and navigational equipment carried on board in compliance with the relevant requirements of chapters III, IV and V of the SOLAS Convention.” To fulfil this requirement it is necessary to survey the chosen cables and cable installation with regard to EMC. Basic rules for cabling in international shipbuilding are presently specified in the series of standards given in IEC 60092 [1]1, requirements on dimensions of routing distances in cable systems are given in IEC 60533 and basic requirements on cable routing in IEC 60092-352. As the requirements differ between the relevant documents, the question of validity has been discussed internationally. This applies particularly in regard to parallel routing of power electronics cables on the one hand and measuring and control equipment cables on the other hand. General Information about routing distances is mainly based on the German standard VG 95375-3 [4]. This standard is based on tests performed in 1982 [2]. In those days tests were performed mainly with sinusoidal signals in the frequency range of 0.1 MHz up to > 40 MHz and even today there is no reason to doubt these test results. However, the question has often been raised whether these results are also adequate for unacceptable crosstalk into cables for integrated digital circuits.

Scope: This Technical Report describes tests methods carried out to determine minimum routing distances in order to avoid crosstalk of fast transients (bursts). The test results may be applied to cable installations according to IEC 60092-352.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 62482-2008 PDF

IEC TR 62482-2008 PDF

$50.44 $100.88