IEC TR 62627-06-2014 PDF

IEC TR 62627-06-2014 PDF

Fibre optic interconnecting devices and passive components-Part 06: Mechanical design proving nutation test results for reinforced fibre cable terminated with optical connectors for high density patching applications

$25.22 $50.44 -50%
Product Code: IEC TR 62627-06
Stock In Stock
Edition: 1.0
Published: 05/2014
Number of Pages: 14
File Size: 1 file, 308 Bytes

Available Options

Product Description

Fibre optic interconnecting devices and passive components – Part 06: Mechanical design proving nutation test results for reinforced fibre cable terminated with optical connectors for high density patching applications

Introduction: Optical connectors are widely used in a variety of optical communication systems. These connectors are sometimes used in high density equipment. When an optical fibre cable assembly is connected to a receptacle port, the optical fibre cable assembly connected to an adjacent port may be pulled to one side. During this operation, the pulling force has the potential to act on the optical fibre cable in an oblique direction. When an optical fibre cable assembly is pulled to one side, the tensile force acts on the optical connector in various directions. The optical connector has to possess mechanical durability to withstand the tensile force imposed on it, and an allowable tensile force should be defined to ensure that the system can continue to operate. Therefore test methods are used to evaluate the mechanical durability when an optical fibre cable assembly is pulled laterally. One of these tests methods is nutation. The IEC Japan National Committee (JPNC) undertook research on a nutation test for optical connectors terminated with reinforced fibre cable.

Scope: This part of IEC 62627, which is a technical report, describes the results of mechanical design proving tests for a high density systems application, carried out using the nutation test according to IEC 61300-2-35, performed on reinforced fibre cable terminated with optical connectors. A tensile load is suggested for the design proving requirements to be used to ensure that connectors meet the mechanical design requirements of connectors for specific application.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 62627-06-2014 PDF

IEC TR 62627-06-2014 PDF

$25.22 $50.44