Printed electronics – Part 304-1: Equipment – Sintering – Temperature measurement method for photonic sintering system
Introduction: The purpose of this document is to describe temperature measurement methods for the photonic sintering system. In the printed electronics industry, metallic nano particles (NPs) such as gold (Au), platinum (Pt), silver (Ag) and copper (Cu) are used as the type of ink or paste to print the desired patterns on paper or polymeric film for a wide range of applications, including printed sensors, organic solar cells, printed batteries, signage, lighting and wearable devices. Additionally, various organic and inorganic inks are used, including etch resist ink, photo solder resist ink, conductive polymer ink, and quantum dot ink. The photonic sintering system is used to heat the printed inks to show a better electrical performance such as electric conductivity, hole mobility in semiconductors, etc. whose standard test methods are shown in IEC 62899- 202 and IEC 62899-203. Among the sintering techniques, the photonic sintering technique is attracting much attention as the most promising alternative sintering technique to replace conventional thermal sintering, in terms of short processing times for low temperature. The advantage of a low temperature in the printed electronics application is that there is less structural degradation of the substrate because the printing process and post sintering process are performed at the low temperature on flexible substrates like paper or polymer. The photonic sintering system is heating equipment with one or more flash lamps, and the surface tem
Scope: This part of IEC 62899, which is a technical report, provides technical information relating to surface temperature measurement of the substrate containing the printed patterns and films applicable to the photonic sintering system used in the printed electronics industry.
Contents:
- FOREWORD
- INTRODUCTION
- Scope