IEC TR 63367-2021 PDF

IEC TR 63367-2021 PDF

Fibre optic interconnecting devices and passive components-Summarising results of round robin on connector end face scratch recognition and verification by automated microscopes

$163.93 $327.86 -50%
Product Code: IEC TR 63367
Stock In Stock
Edition: 1.0
Published: 11/2021
Number of Pages: 44
File Size: 1 file, 8 Bytes

Available Options

Product Description

Fibre optic interconnecting devices and passive components – Summarising results of round robin on connector end face scratch recognition and verification by automated microscopes

Introduction: It is known that contamination and scratches on connector end face can result in degradation of optical performance as described in IEC TR 62627-05. It is important to inspect and clean, when necessary, each connector before mating with another connector to ensure they are fit for function. The visual inspection methods and criteria for fibre optic connectors and fibre-stub transceivers are defined in IEC 61300-3-35. Three different methods can be used for visual inspection: direct view optical microscopy (method A), video microscopy (method B) and automated analysis microscopy (method C). All methods are susceptible to system variability: methods A and B are operator dependent; method C is operator independent but relies on software analysis for measurement results. The uncertainty inherent to imaging equipment, processing methods, and detection software can lead to measurement variability among different brands and even the same types of microscopy. For all methods, the fibre microscopes can be certified for use in either low- and high-resolution applications with a purpose-built certification artefact. There is industry concern about the veracity of the results of the visual inspection of the same part using different automated inspection equipment and software for method C. The IEC SC 86B task force group on scratch recognition was organized to investigate automated inspection system variability and provide recommendations to improve repeatability and reproducibility of t

Scope: This document summarises the results of a round robin on connector end face scratch recognition and verification by automated microscopes. The prime objectives of the study were: determine the amount of variability (repeatability and reproducibility) when different state- of-the-art inspection systems are assessed against IEC 61300-3-35:2015; evaluate any system-to-system variation in the quantity of reported scratches; provide recommendations to improve the repeatability and reproducibility of fibre optic inspection systems.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 63367-2021 PDF

IEC TR 63367-2021 PDF

$163.93 $327.86