IEC TS 60034-27-6-2026 PDF

IEC TS 60034-27-6-2026 PDF

Rotating electrical machines - Part 27-6: On-line partial discharge measurements of rotating machine windings supplied from a converter

$100.88 $201.76 -50%
Product Code: IEC TS 60034-27-6
Stock In Stock
Edition: 1.0
Published: 05/2026
Number of Pages: 26
File Size: 1 file, 810 KB

Available Options

Product Description

Rotating electrical machines - Part 27-6: On-line partial discharge measurements of rotating machine windings supplied from a converter

Introduction: The on-line measurement of partial discharges (PD) is a well-established technology to help assess if deterioration has occurred in the electrical insulation of form-wound stator windings in motors and generators rated 3 kV and above that are directly connected to the 50/60 Hz power system. Such on-line testing helps machine owners determine when stator winding maintenance is required. IEC 60034-27-2 provides methods for on-line PD detection, as well as advice on interpretation. However, the methods described in IEC 60034-27-2, in general, are not effective when applied to machines connected to most common types of AC frequency converters. This is because the AC fundamental frequency is not fixed, and since some types of drives (and the voltage source PWM converter in particular) produce high voltage impulses that in many respects have the same shape as PD pulses but are orders of magnitude higher than the PD pulses. The interference from the voltage impulses from operating converters can obscure the winding PD and make on-line measurement difficult if not impossible using the methods intended for machines fed from industrial sinusoidal AC voltage. IEC TS 60034-27-5 is concerned with the off-line measurement of PD in windings caused by voltage impulses from specialized impulse test supplies. Usually, these voltage impulses are few in number per second, and the impulse waveform is well-behaved, reducing the risk of false indications. In contrast there are often thousands of im

Scope: This part of the IEC 60034-27 deals with the on-line electrical detection and monitoring of partial discharges on both motors and generators whose rotor windings or stator windings, or both, are supplied from converters. The tests are applicable to both type I and type II insulation systems, encompassing AC windings rated 300 V and above. Details of non-electrical methods such as optical or acoustic detection are not included. The on-line measurement of PD where the winding is supplied via slip rings are also not covered.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 60034-27-6-2026 PDF

IEC TS 60034-27-6-2026 PDF

$100.88 $201.76