Rotating electrical machines – Part 32: Measurement of stator end-winding vibration at form-wound windings
Introduction: Large alternating current (AC) machines are equipped with multiphase stator windings. The information in this document is based on a dual-layer design. Such windings are connected to a multiphase voltage system (multiphase current system), which establishes a rotating magnetic field in the air gap between the rotor surface and stator bore. The voltage and current can vary during operation in order to adapt to varying mechanical load. Electrical machines are normally designed for motor or generator operating mode. The majority of AC machines are equipped with symmetrical three-phase windings, consisting of three, electrically isolated, spatially distributed winding parts that are intended for common operation. Large AC rotating electrical machines are typically equipped with form-wound windings consisting of form wound coils (as defined in IEC 60034-15:2009, 2.3), single winding coils (single winding bars) which are given their shape before being assembled into the machine. The winding overhang, or end-winding, is the portion of the stator winding that extends beyond the end of the magnetic core and is, in most cases, formed as a circular cone, see some examples in Figure 1 below. NOTE Individual coil end marked with black line. Figure 1 – Stator end-winding of a turbogenerator (left) and a large motor (right) at connection end with parallel rings IEC
Scope: This part of IEC 60034 is intended to provide consistent guidelines for measuring and reporting end-winding vibration behaviour during operation and at standstill. It defines terms for measuring, analysis and evaluation of stator end-winding vibration and related structural dynamics, gives guidelines for measuring dynamic / structural characteristics offline and stator end- winding vibrations online, describes instrumentation and installation practices for end-winding vibration measurement equipment, establishes general principles for documentation of test results, describes the theoretical background of stator end-winding vibrations. This part of IEC 60034 is applicable to: three-phase synchronous generators, having rated outputs of 150 MVA and above driven by steam turbines or combustion turbines; three-phase synchronous direct online (DOL) motors, having rated output of 30 MW and above. This document is limited to the description of measurement procedures for 2-pole and 4-pole machines. For smaller ratings of machines than defined in this document, agreement can be made between the vendor and the purchaser for the selection of measurements in this document to be applied.
Contents:
- FOREWORD
- INTRODUCTION
- Scope