IEC TS 60695-11-12-2026 PDF

IEC TS 60695-11-12-2026 PDF

Fire hazard testing - Part 11-12: Test flames - Burning droplets test for finished units

$25.22 $50.44 -50%
Product Code: IEC TS 60695-11-12
Stock In Stock
Edition: 1.0
Published: 09/2026
Number of Pages: 16
File Size: 1 file, 380 KB

Available Options

Product Description

Fire hazard testing - Part 11-12: Test flames - Burning droplets test for finished units

Introduction: In the design of any electrotechnical product, the risk of abnormal heat and the potential hazards associated with abnormal heat need to be considered. In this respect the objective of component, circuit, and product design, as well as the choice of materials, is to reduce to acceptable levels the potential risks during normal operating conditions, reasonably foreseeable abnormal use, malfunction and/or failure. IEC Technical Committee 89 has developed IEC 60695-1-10 [1], together with its companion IEC 60695-1-11 [2], to provide guidance on how this is to be accomplished. The primary aims of IEC 60695-1-10 [1] and IEC 60695-1-11 [2] are to provide guidance on how: a) to prevent ignition caused by an electrically energized component part, and b) to confine any resulting fire within the bounds of the enclosure of the electrotechnical product in the event of ignition. Secondary aims of IEC 60695-1-10 [1] and IEC 60695-1-11 [2] include the minimization of any flame spread beyond the product’s enclosure and the minimization of the harmful effects of fire effluents such as heat, smoke, toxicity and/or corrosivity. IEC TC 108 (Safety of electronic equipment within the field of audio/video, information technology and communication technology) has used the hot flaming oil test in the past to test the adequacy of the bottom of a fire enclosure (see IEC 60950-1:2005/AMD2:2013 [3], 4.6.2 and Clause A.3, Hot Flaming Oil Test). While this test was representative in times where oil was use

Scope: This part of IEC 60695, which is a technical specification, describes a test method intended to investigate whether the bottom part of an enclosure having openings is able to contain the burning droplets inside the enclosure if ignition occurs inside a finished unit. The purpose of the test is to verify whether the size of the openings in the bottom part of an enclosure are of such a size that reduces the risk of propagation of a flame outside the enclosure of a finished unit. This technical specification is intended to be used by technical committees in the preparation of documents in accordance with the principles laid down in IEC GUIDE 104 [4] and ISO/IEC Guide 51 [5]. While this document currently does not have the status of a horizontal safety publication, it is intended to become one if the document is transformed into an International Standard. NOTE One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this technical specification will not apply unless specifically referred to or included in the relevant publications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 60695-11-12-2026 PDF

IEC TS 60695-11-12-2026 PDF

$25.22 $50.44