IEC TS 60695-2-20 (REDLINE + STANDARD)-2024 PDF

IEC TS 60695-2-20 (REDLINE + STANDARD)-2024 PDF

Fire hazard testing-Part 2-20: Glowing/hot wire based test methods-Hot-wire ignition (HWI) test method test method-Apparatus, verification, test method and guidance

$42.88 $85.75 -50%
Product Code: IEC TS 60695-2-20 (REDLINE + STANDARD)
Stock In Stock
Edition: 4.0
Published: 11/2024
Number of Pages: 62
File Size: 1 file

Available Options

Product Description

Fire hazard testing – Part 2-20: Glowing/hot wire based test methods – Hot-wire ignition (HWI) test method test method – Apparatus, verification, test method and guidance

Introduction: In the design of any electrotechnical product, the risk of abnormal heat and the potential hazards associated with abnormal heat need to be considered. In this respect the objective of component, circuit, and product design, as well as the choice of materials, is to reduce to acceptable levels the potential risks during normal operating conditions, reasonably foreseeable abnormal use, malfunction and/or failure. IEC 60695-1-10 [1]1, together with its companion IEC 60695-1-11 [2], provides guidance on how this is to be accomplished. The primary aims of IEC 60695-1-10 [1] and IEC 60695-1-11 [2] are to provide guidance on how: a) to prevent ignition caused by an electrically energized component part, and b) to confine any resulting fire within the bounds of the enclosure of the electrotechnical product in the event of ignition. Secondary aims of IEC 60695-1-10 [1] and IEC 60695-1-11 [2] include the minimization of any flame spread beyond the product's enclosure and the minimization of the harmful effects of fire effluents such as heat, smoke, toxicity and/or corrosivity. The test method provided in this document applies to solid electrical insulating materials which can provide test specimens. It applies to materials for which the test specimen does not deform during preparation, especially during the winding of the test specimen with the heater wire as described in 5.5. Examples of deformation that render this test method inapplicable include: a) bowing, in either a transverse

Scope: This part of IEC 60695, which is a technical specification, describes a test method that applies to solid electrical insulating materials of which test specimens can be provided. The test measures the time required to ignite a test specimen when it is affected by heat from an electrically heated wire wound around the test specimen. If the test specimen drips, the time at which this occurs is also recorded. The test method can be used to provide classifications which can be used for quality assurance, the preselection of materials of products as described in IEC 60695-1-30, or to verify the required minimum classification of materials used in end products. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 60695-2-20 (REDLINE + STANDARD)-2024 PDF

IEC TS 60695-2-20 (REDLINE + STANDARD)-2024 PDF

$42.88 $85.75