IEC TS 60695-6-30-2013 PDF

IEC TS 60695-6-30-2013 PDF

Fire hazard testing-Part 6-30: Smoke obscuration-Small-scale static method-Apparatus

$163.93 $327.86 -50%
Product Code: IEC TS 60695-6-30
Stock In Stock
Edition: 2.0
Published: 04/2013
Number of Pages: 84
File Size: 1 file

Available Options

Product Description

Fire hazard testing – Part 6-30: Smoke obscuration – Small-scale static method – Apparatus

Introduction: The risk of fire needs to be considered in any electrical circuit, and the objective of component, circuit and equipment design, and the choice of materials, is to reduce the likelihood of fire, even in the event of foreseeable abnormal use, malfunction or failure. Electrotechnical products, primarily as victims of fire, may nevertheless contribute to the fire. One of the contributing hazards is the release of smoke, which may cause a reduction of visibility and/or orientation which could impede escape from the building, or could impede fire fighting. Consequently, a reduction in the amount and the rate of generation of smoke produced by materials/products during a fire reduces damage to equipment, facilitates evacuation of people and facilitates the intervention of emergency services.

Scope: This part of IEC 60695 describes the apparatus, calibration procedures and basic experimental procedures for the determination of the specific optical density of smoke produced by materials exposed vertically to a radiant heat source with or without the application of a pilot flame. The test specimens are of a defined size. The determination of the optical density is carried out in a pressure-controlled chamber previously calibrated with reference materials. The test methods are only applicable to flat, solid, non-metallic test specimens, of materials used in electrotechnical products. This technical specification does not provide a classification system for the behaviour of materials. The test methods are not applicable for materials that melt and flow away from the direct impingement of heat flux. The test methods are not recommended for further development for electrotechnical products nor are they recommended as the basis for regulation or other controls on smoke release due to the limitations of the physical fire model and the test specimen geometry – see Clause 4. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 60695-6-30-2013 PDF

IEC TS 60695-6-30-2013 PDF

$163.93 $327.86