IEC TS 60695-8-3-2008 PDF

IEC TS 60695-8-3-2008 PDF

Fire hazard testing-Part 8-3: Heat release-Heat release of insulating liquids used in electrotechnical products

$50.44 $100.88 -50%
Product Code: IEC TS 60695-8-3
Stock In Stock
Edition: 1.0
Published: 04/2008
Number of Pages: 34
File Size: 1 file, 950 Bytes

Available Options

Product Description

Fire hazard testing – Part 8-3: Heat release – Heat release of insulating liquids used in electrotechnical products

Introduction: In the design of any electrotechnical product, the risk of fire and the potential hazards associated with fire need to be considered. In this respect, the objective of component, circuit and equipment design, as well as the choice of materials, is to reduce to acceptable levels the potential risks of fire even in the event of foreseeable abnormal use, malfunction or failure. The future IEC 60695-1-10 [1] 1, together with its companion, the future IEC 60695-1-1 [2], provide guidance on how this is to be accomplished. The primary aims are to prevent ignition caused by an electrically energized component part and, in the event of ignition, to confine any resulting fire within the bounds of the enclosure of the electrotechnical product. Secondary aims include the minimization of any flame spread beyond the product’s enclosure and the minimization of harmful effects of fire effluents including heat, smoke and toxic or corrosive combustion products. Fires involving electrotechnical products can also be initiated from external non-electrical sources. Considerations of this nature are dealt with in the overall risk assessment. Fires are responsible for creating hazards to life and property as a result of the generation of heat (thermal hazard), the production of toxic and/or corrosive compounds, and the obscuration of vision due to smoke. Fire risk increases as the heat released increases, possibly leading to a flash-over fire. One of the most important measurements in fire testing i

Scope: IEC 60695-8-3, which is a technical specification, specifies quantitative test methods for determining the heat release from the combustion of insulating liquids of electrotechnical products when exposed to a defined heat flux with spark ignition. Smoke production, ignition times and mass loss are also measured. This technical specification may also be applicable to other liquid test specimens. This technical specification is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and in ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications. HAZARD WARNING The testing of volatile liquids with this apparatus can lead to explosions so it is essential to examine all liquids using the preliminary testing procedure described in 8.1.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • Introduction
  • 10 Test report
  • 11 Precision data

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 60695-8-3-2008 PDF

IEC TS 60695-8-3-2008 PDF

$50.44 $100.88