IEC TS 61400-29-2023 PDF

IEC TS 61400-29-2023 PDF

Wind energy generation systems-Part 29: Marking and lighting of wind turbines

$132.41 $264.81 -50%
Product Code: IEC TS 61400-29
Stock In Stock
Edition: 1.0
Published: 02/2023
Number of Pages: 34
File Size: 1 file, 1 Byte

Available Options

Product Description

Wind energy generation systems – Part 29: Marking and lighting of wind turbines

Introduction: As the Wind Industry grows, airspace users (military, civil and emergency aircraft) need to continue to operate safely in an environment that includes wind turbines, and the two industries need to exist harmoniously. To assist in creating a safe environment, some wind turbines are required to have aeronautical lights so they can be seen by airspace users. Unfortunately, some of these lights can have an adverse visual impact, which produces lighting pollution for nearby communities. Annex 14 to the Convention on International Civil Aviation published by the International Civil Aviation Organization (ICAO) contains Standards and Recommended Practices (specifications) that prescribe the marking and lighting of wind turbines. However, many countries have interpreted these specifications differently and issued their own guidelines and conditions to suit their local requirements. Therefore, there is little homogeneity and wind turbine manufacturers are obliged to produce bespoke designs to suit specific markets. There are currently approximately 20 different marking and lighting specifications for countries such as Belgium, Brazil, Canada, Finland, France, Germany and Japan. In many cases, those requirements are very similar. However, they often differ in terms of light intensity, positioning and markings, which could lead to confusion and reduction in air safety. In some cases wind farms that are separated by only a few kilometers are marked and illuminated in accordance with diff

Scope: This part of IEC 61400, which is a Technical Specification, instils good practice for aviation lighting and marking of wind turbines in both onshore and offshore domains. Consideration is given to visible lighting and infrared (IR) lighting, which is necessary to maintain conspicuity to users of night vision goggles (NVGs). ICAO Annex 14 Standards and Recommended Practices have been used as the basis to develop supplementary harmonised specifications to assist with implementation. This document provides a set of technical requirements for marking and lighting of wind turbines with a tip height from/at 150 meters and below 315 meters Above Ground Level (AGL), or Above Mean Sea Level (AMSL) for offshore sites. This will improve situational awareness for airspace users, maintain safety of aircraft flying in the vicinity of wind turbines, and provide additional tools to assist with the reduction in environmental impacts consistent with aviation safety objectives. In the event that the wind turbine development exceeds 315 m tip height and the regulatory frameworks is updated to cater for these heights, this document will be reviewed and amended as necessary. In the absence of an update to the regulatory framework, the guidance in this document is to be followed as a minimum. In some cases, lighting may be required for wind turbines at or below 150 meters tip height. However, this is not in the scope of this document and in these situations, the developer should contact the relevant National Aviation Authority or Planning Authority for further guidance.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 61400-29-2023 PDF

IEC TS 61400-29-2023 PDF

$132.41 $264.81