Electric vehicle conductive charging system – Part 3-1: DC EV supply equipment where protection relies on double or reinforced insulation – General rules and requirements for stationary equipment
Introduction: This document is published in separate parts according to the following structure: IEC TS 61851-3-1, Electric vehicle conductive charging system – Part 3-1: DC EV supply equipment where protection relies on double or reinforced insulation – General rules and requirements for stationary equipment IEC TS 61851-3-2, Electric vehicle conductive charging system – Part 3-2: DC EV supply equipment where protection relies on double or reinforced insulation – Particular requirements for portable and mobile equipment IEC TS 61851-3-4, Electric vehicle conductive charging system – Part 3-4: DC EV supply equipment where protection relies on double or reinforced insulation – General definitions and requirements for CANopen communication IEC TS 61851-3-5, Electric vehicle conductive charging system – Part 3-5: DC EV supply equipment where protection relies on double or reinforced insulation – Pre-defined communication parameters and general application objects IEC TS 61851-3-6, Electric vehicle conductive charging system – Part 3-6: DC EV supply equipment where protection relies on double or reinforced insulation – Voltage converter unit communication IEC TS 61851-3-7, Electric vehicle conductive charging system – Part 3-7: DC EV supply equipment where protection relies on double or reinforced insulation – Battery system communication
Scope: This part of IEC 61851, which is a Technical Specification, applies to the equipment, including stationary equipment for the conductive transfer of electric power between the supply network and an electric road vehicle, or a removable rechargeable energy storage system (RESS), or an on-board RESS of an electric road vehicle, when the equipment is connected to the supply network having a supply voltage up to 480 V AC or up to 400 V DC and a rated output voltage up to 120 V DC, and where the protection against electric shock relies on double or reinforced insulation, and with double or reinforced insulation between all AC and DC inputs and outputs. NOTE 1 In the following countries, the acceptable nominal supply voltage is up to 600 V AC: CA, US. Particular requirements for portable and mobile DRI EV supply equipment are covered by IEC TS 61851-3-2023. Equipment for the conductive transfer of electric power between the supply network and an electric road vehicle/RESS according to the IEC TS 61851-3 series is intended to be connected to vehicles where the vehicle power supply circuit is protected against electric shock by double or reinforced insulation. NOTE 2 For information regarding protection against electric shock by double or reinforced insulation of the EV or of the vehicle power supply circuit, see ISO 18246:2023, 6.1.1 b) and Table 3. Requirements for bidirectional energy transfer DC to AC are under consideration and are not part of this document. This document also applies to EV supply equipment supplied from on-site storage systems (e.g. buffer batteries). This document applies to VCUs intended to be a part of DRI EV supply equipment specified in this document. This document applies to equipment for the conductive transfer of electric power between the supply network and an electric road vehicle/RESS intended to be installed and/or used at an altitude of up to 2 000 m. The aspects covered in this document include the connection to the vehicle, characteristics to be complied with by the vehicle with respect to the AC or DC, the specification for required level of electrical safety for the double or reinforced insulated (DRI) EV supply equipment, IEC TS 6
Contents:
- FOREWORD
- INTRODUCTION
- Scope