IEC TS 61895-1999 PDF

IEC TS 61895-1999 PDF

Ultrasonics - Pulsed Doppler Diagnostic Systems - Test Procedures to Determine Performance

$163.93 $327.86 -50%
Product Code: IEC TS 61895
Stock In Stock
Edition: 1.0
Published: 10/1999
Number of Pages: 40
File Size: 1 file, 237 Bytes

Available Options

Product Description

Ultrasonics - Pulsed Doppler Diagnostic Systems - Test Procedures to Determine Performance

Introduction: Pulsed ultrasonic Doppler flowmeters and velocimeters are widely used in clinical practice, usually in combination with real-time B-mode imaging and colour-flow imaging instruments. The device periodically transmits pulses of ultrasound from an ultrasound transducer and measures the Doppler shift in the frequency of ultrasound reflected and scattered from moving tissues. This Doppler shift is proportional to the component of reflector or scatterer velocity along the ultrasound beam. By looking for Doppler shifts in the received signal at specific times after transmission (range-gating), the device can be used to determine the variation of tissue velocity with distance along the ultrasound beam. The device is sensitive to movement only within a region of the beam called the sample volume. The position of the sample volume along the beam may be adjusted by altering the delay between transmission and range-gating. Multi- channel devices have a number of sample volumes operating simultaneously. The pulsed ultrasonic device is most commonly used to investigate blood flow when the ultrasound is scattered from red blood cells. This technical specification describes a range of tests which may be used to measure performance and the test objects required. In many cases, the test method and test object have been described in IEC 61206 and in these cases reference is simply made to this document. Other tests and test objects are described in [1] and [2]. The test methods may be considere

Scope: This technical specification describes test methods for measuring the performance of pulsed Doppler ultrasound systems; Doppler test objects for carrying out these tests; and applies to tests made on an overall pulsed Doppler ultrasound system, a system which is not disassembled or disconnected; tests made on pulsed Doppler ultrasound systems whether they are stand-alone or as part of another ultrasound instrument. Electrical safety, acoustic output and electromagnetic compatibility (EMC) are not covered in this technical specification. The workload to perform all described tests is, in general, prohibitive. It is intended that a subset of the described tests is adopted for regular use. However, experience to give guidance for selection has still to be gathered and will be the subject of ongoing work.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 5.2.10 Working pulse repetition frequency (PRF)
  • 5.2.11 Doppler (receiver) gain
  • 5.2.12 Test frequency
  • 5.2.13 Working sample volume length
  • 5.2.14 Doppler signal power measurement

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 61895-1999 PDF

IEC TS 61895-1999 PDF

$163.93 $327.86