Power installations exceeding 1 kV AC and 1,5 kV DC – Part 0: Principles to be observed in the design and erection of high voltage installations – Safety of high voltage installations
Introduction: The scope of TC 99 is the standardisation of insulation co-ordination for high voltage systems and common rules and particular requirements for system engineering and erection of high voltage electrical power installations for power generation, transmission, distribution, and consumer premises, in both indoor and outdoor situations, with particular consideration of safety aspects. With the increasing development of electric power systems and renewable energy devices, there is an increasing demand for Technical Committees to define installations, systems and equipment at voltages above 1,0 kV AC and 1,5 kV DC. This requirement became evident during the activities of TC 99 AhG6's discussions with TC 18 and TC 88 where a review of documents prepared by these TCs showed that there was a need for a document which defines principles to be observed in design and the erection of HV installations. The objective of this document is to give the principles for TCs in how to define requirements with respect to HV installations to ensure that safety of such systems is maintained and that a consistent approach is taken by all TCs involved with HV installations with respect to design, operation and maintenance of installation at voltages above 1,0 kV AC and 1,5 kV DC. Figure 1 below describes the relationship of this document to other IEC standards: Figure 1 – Relationship of IEC 61936-0 to other IEC standards
Scope: This part of IEC 61936 provides principles to ensure the coherence amongst HV publications to be observed necessary for the coordination of the design, selection of equipment, operation, and maintenance activities for erection of electrical HV installations to ensure the safety of such systems. In the context of this document, "safety" relates to the safety of persons, domestic animals, livestock and property. This Technical Specification is intended for use by technical committees in the preparation of standards with safety aspects which can be a part of an electrical high voltage installation.
Contents:
- FOREWORD
- INTRODUCTION
- Scope