Recommendations for renewable energy and hybrid systems for rural electrification – Part 8-1: Selection of batteries and battery management systems for stand-alone electrification systems – Specific case of automotive flooded lead-acid batteries available in developing countries
Introduction: The IEC 62257 series of documents intends to provide to different players involved in rural electrification projects (such as project implementers, project contractors, project supervisors, installers) with documents for the setting up of renewable energy and hybrid systems with AC voltage below 1 000 V and DC voltage below 1 500 V. These documents are recommendations: to choose the right system for the right place; to design the system; to operate and maintain the system. These documents are focused only on rural electrification concentrating on, but not specific to, developing countries. They are not considered as all-inclusive to rural electrification. The documents try to promote the use of renewable energies in rural electrification; they do not deal with clean mechanisms developments at this time (CO2 emissions, carbon credit, etc.). Further developments in this field could be introduced in future steps. This consistent set of documents is best considered as a whole with different parts corresponding to items for safety, sustainability of systems and at the lowest life cycle cost possible. One of the main objectives is to provide the minimum sufficient requirements relevant to the field of application that is: small renewable energy and hybrid off-grid systems. For rural electrification projects using PV systems, it is recommended to use solar batteries defined in IEC 61427. Nevertheless in many situations, it is a fact that most of the rural electrification projects ar
Scope: This part of IEC 62257 proposes simple, cheap, comparative tests in order to discriminate easily, in a panel of automotive flooded lead-acid batteries, the most acceptable model for PV individual electrification systems. It could be particularly useful for project implementers to test in laboratories of developing countries, the capability of locally made car or truck batteries to be used for their project. Furthermore, battery-testing specifications usually need test equipment that is too costly and too sophisticated to be applied in developing countries' laboratories. The tests provided in this document allow assessment of the batteries' performances according to the general specification of the project (see IEC TS 62257-2) and batteries associated with their battery management system (BMS) in a short time and with common technical means. They can be performed locally, as close as possible to the operating conditions of the real site. The document provides also regulations and installation conditions to be complied with in order to ensure the life and proper operation of the installations as well as the safety of people living in proximity to the installation. This document is not a type approval standard. It is a technical specification to be used as guidelines and does not replace any existing IEC standard on batteries.
Contents:
- FOREWORD
- INTRODUCTION
- Scope