Recommendations for renewable energy and hybrid systems for rural electrification – Part 9-3: Integrated systems – User interface
Introduction: The IEC 62257 series intends to provide to different players involved in rural electrification projects (such as project implementers, project contractors, project supervisors, installers, etc.) documents for the setting up of renewable energy and hybrid systems with a.c. nominal voltage below 1 000 V and d.c. nominal voltage below 1 500 V. These documents are recommendations: to choose the right system for the right place, to design the system, to operate and maintain the system. These documents are focused only on rural electrification concentrating on but not specific to developing countries. They should not be considered as all inclusive to rural electrification. The documents try to promote the use of renewable energies in rural electrification; they do not deal with clean mechanisms developments at this time (CO2 emission, carbon credit, etc.). Further developments in this field could be introduced in future steps. This consistent set of documents is best considered as a whole with different parts corresponding to items for safety, sustainability of systems and at the lowest life cycle cost as possible. One of the main objectives is to provide the minimum sufficient requirements, relevant to the field of application that is: small renewable energy and hybrid off-grid systems.
Scope: This part of IEC 62257, which is a technical specification, specifies the general requirements for the design and the implementation of the interface equipment within the user’s installation which connects to a microgrid or the generating part of a standalone system. This interface is a part of the user’s installation as shown in Figure 1. Figure 1 – General configuration of an electrification system This part of IEC 62257 applies to simplified user's interfaces (distribution board) in electrical installations with maximum power of 500 VA in Decentralized Rural Electrification Systems (DRESs). NOTE For installations above 500 VA in decentralized electrification systems, IEC TS 62257-5 applies. This part of IEC 62257 applies to an interface equipment within the user’s installation and which connects the user's installation to: 240 V or 230 V or 220 V or 120 V a.c. microgrid, the generating part – a.c. or d.c. – of a standalone installation. This equipment provides protection, isolation, and distribution functions.
Contents:
- FOREWORD
- INTRODUCTION
- Scope