Safeguards against accidentally caused candle flame ignition for audio/video, communication and information technology equipment
Introduction: The first version of this technical specification was discussed at the TC108 plenary meeting in Matsue, Japan in October 2008. It was decided to extend the TS for another three year period and to implement some changes as previously agreed in several TC108 meetings. The text of this technical specification is based on the outcome of these discussions. In line with SMB decision 135/20 and document AC/22/2009, it is anticipated that the next step for this document would be a proposal for publication as an International Standard, taking into account any further developments regarding the improvement of these requirements. It should be noted that the Fire Team of the HBSDT (Hazard based standard development team) developed requirements on a Heat Release Rate Performance Test and recommended a peak Heat Release Rate (pHRR) value of 50 KW for equipment covered by the standard. It also generated test data for the specific pre-selection criteria for equipment, such as keyboards, that have fuels that are predominantly horizontal in their construction. Development testing that had been conducted included assessment of products that were difficult to ignite with a candle and that passed preliminary pHRR testing with significant margin. However, these products commonly use fuels that may not pass 1) the flammability rating, 2) the material weight exemption, or 3) the sustained ignition testing. These additional requirements and test methods did not give the same level of reproducibility
Scope: This technical specification introduces safeguards to reduce the likelihood of room flash-over as a result of accidental ignition of exterior housings of audio/video and information communication technology products likely to be used in the home, caused by a candle flame. NOTE According to AC/22/2009 and SMB decision 135/20, this technical specification should currently only be used for television sets. It can be used for other products only if a risk assessment indicates problems with these products.
Contents:
- FOREWORD
- INTRODUCTION
- Scope