Nanomanufacturing – Key control characteristics – Part 2-1: Carbon nanotube materials – Film resistance
Introduction: There are two major trends in the fabrication of new materials incorporating carbon nanotubes (CNTs) for next generation of industrial applications: a) conducting composites in field-emission displays (FEDs), flexible displays, or printed electronics; and b) nano-composites for mechanical applications, by taking advantage of their attractive mechanical properties such as high Young’s modulus, elastic behaviour and high tensile strength. This IEC technical specification is related to a), the conducting composites application. As conducting composites using CNTs are increasingly being used in the electronics industry, it is essential to establish a standard method to evaluate their electrical properties. Characterization of the electrical properties of CNTs used in conducting composites is important to both manufacturers and users. This IEC technical specification describes simple methods to characterize the electrical properties of CNT materials that are to be used in conducting composites.
Scope: This part of IEC 62607 provides a standardized method for categorizing a grade of commercial CNTs in terms of their electrical properties to enable a user to select a CNT material suitable for their application. The method is intended to assess whether the delivered materials from different production batches of the same production process are comparable regarding electrical properties of the final product which are related to electrical conductivity. The correlation between the measured parameters by the proposed method and a relevant product performance parameter has to be established for every application. This specification includes a) definitions of terminology used in this document, b) recommendations for sample preparation, c) outlines of the experimental procedures to measure sheet resistance of CNTs in thin films, d) methods of interpretation of results and discussion of data analysis, e) case studies and, f) references. Terms, definitions, acronyms and abbreviations For the purposes of this document, the following terms and definitions apply. NOTE A comprehensive nanotechnology vocabulary is under ongoing development in IEC TC113/ISO TC229 Joint Working Group 1 in cooperation with ISO/TC 229. The vocabulary is/will be published as different parts of IEC/ISO/TS 80004. This document will be harmonized with the terms and definitions of TS 80004 prior to publication and later on during the maintenance of the document. Definitions not yet specified are taken from scientific literature. 2.1 Terms and definitions 2.1.1 single-wall carbon nanotube SWCNT carbon nanotube consisting of a single cylindrical graphene layer Note 1 to entry: Its structure corresponds to a graphene sheet rolled up into a seamless honeycomb structure around a cylinder. [SOURCE: ISO/TS 80004-3:2010, definition 4.4] 2.1.2 multiwall carbon nanotube MWCNT carbon nanotube composed of nested, concentric or near-concentric graphene sheets with interlayer distances similar to those of graphite Note 1 to entry: Its structure is considered to be many single-wall carbon nanotubes nesting each other, and would be cylindrical for small diameters but tends to have a polygonal cross section as the di
Contents:
- FOREWORD
- INTRODUCTION
- Scope