Nanomanufacturing – Key control characteristics – Part 4-4: Nano-enabled electrical energy storage – Thermal characterization of nanomaterials, nail penetration method
Introduction: Energy storage devices are becoming increasingly important for many applications such as consumer devices, electric vehicles and aircrafts. Energy storage devices with high performance and reliability are the key factors to earn the confidence of customers. Also, in smart grid and renewable energy applications, where energy efficiency and reliable power supplies are critical, an energy storage system is an essential device. There are many types of energy storage devices for various applications. Lithium-ion batteries are the most popular and promising energy storage devices for portable electronics, consumer electronics, military, electric vehicle and aerospace applications. It is a good test carrier for performance and reliability characteristics. One of the characteristics that draws the attention of users is the thermal runaway behaviour when a short circuit occurs inside the energy storage devices due to a manufacturing process defect, improper operation or external shocks. The poor control of manufacturing process may cause the energy storage device's internal defects, such as particle impurity, defects of separator, burr of electrodes or a prominence of conductive arms. Energy storage devices operated under abnormal conditions, such as quick charging or piercing by external objects, may cause an internal short circuit. Large current generated short circuit will generate an abnormal exothermic reaction and a local temperature rise, but the temperature of the short circui
Scope: This part of IEC 62607, which is a Technical Specification, provides a measurement method for thermal runaway quality level test for nano-enabled energy storage devices. This method uses comparative measurement to enable a manufacturer to decide whether or not the nanomaterial additives used in energy storage devices are resilient against the thermal runaway caused by a faulty or accidental low resistance connection between two or several internal points depending on the number of stacking electrode layers of the test sample. The nanomaterial additives may mix with the materials of positive and negative electrodes, electrolyte, coated on electrodes or separator. This document includes definitions of terminology, test sample, puncture nail requirements, test procedures, data analysis and methods of interpretation of results and a case study. This document does not apply directly to the safety testing for energy storage device products due to complex safety design schemes embedded in these products.
Contents:
- FOREWORD
- INTRODUCTION
- Scope