Nanomanufacturing – Key control characteristics – Part 6-19: Graphene-based material – Elemental composition: CS analyser, ONH analyser
Introduction: In recent decades, graphene has attracted extensive attention from academy and industry, because of its extraordinary physical and chemical properties for promising applications in energy storage, electronics, composites, etc. For most graphene powder available either in the laboratory or on the market, apart from carbon, the presence of other elements (e.g. sulfur, oxygen, nitrogen, hydrogen) is inevitable in the course of graphene fabrication. Heteroatoms in graphene can change the material's energy band at different levels, thus affecting its electrical properties and thermal conductivity [1],[2]1. Therefore, the heteroatom content is a key control characteristic which helps to ascertain the structure and purity of graphene powder, and its determination is significant for the production and application of graphene. A method used to determine the elemental composition in graphene is the combustion/pyrolysis method, which infers the elemental composition in a sample by analysing the content of the combustion or pyrolysis gases. This method has high analysis efficiency and convenience of operation, but different instruments will provide different levels of measurement uncertainty. In general, the combustion/pyrolysis method is established on an organic elemental analyser (EA), which uses a thermal conductivity detector (TCD) to analyse the components of the combustion or pyrolysis gases. But for graphene powder, EA is not an excellent tool to access the heteroatom content. On
Scope: This part of IEC TS 62607 establishes a standardized method to determine the chemical key control characteristic elemental composition for powder consisting of graphene-based material by CS analyser and ONH analyser. The method as described in this document determines the content of carbon (C), sulfur (S), oxygen (O), nitrogen (N) and hydrogen (H). The carbon (C) and sulfur (S) content in graphene powder is derived by the content of converted CO, CO2 and SO2, which is determined by infrared gas detector (IGD) using a non-dispersive infrared adsorption method in CS analyser. The content of oxygen (O), nitrogen (N) and hydrogen (H) in graphene powder is derived by ONH analyser using pyrolysis method. The O content is obtained according to the content of converted CO and CO2, which is determined by IGD using a non-dispersive infrared adsorption method. The N content is obtained according to the content of converted N2, which is determined by a thermal conductivity detector (TCD) method. The H content is obtained by measuring converted H2 or H2O, corresponding to TCD or IGD method. The method is applicable for graphene, graphene oxide (GO) and reduced graphene oxide (rGO) in powder form.
Contents:
- FOREWORD
- INTRODUCTION
- Scope