IEC TS 62607-6-23-2025 PDF

IEC TS 62607-6-23-2025 PDF

Nanomanufacturing - Key control characteristics - Part 6-23: Graphene-related products - Sheet resistance, carrier density, carrier mobility: Hall bar method

$72.51 $145.02 -50%
Product Code: IEC TS 62607-6-23
Stock In Stock
Edition: 1.0
Published: 11/2025
Number of Pages: 24
File Size: 1 file, 1 Byte

Available Options

Product Description

Nanomanufacturing - Key control characteristics - Part 6-23: Graphene-related products - Sheet resistance, carrier density, carrier mobility: Hall bar method

Introduction: Graphene films are widely used in the fields of electronic devices, e.g. display, communication and wearable devices. Different applications have different requirements on carrier mobility and sheet resistance of graphene films, which determines the performance of graphene films. Carrier mobility and sheet resistance are the key control characteristics for quality control and product development of graphene films. However, there are large differences in carrier mobility extracted from devices in different structures even made from the same thin films. The sheet resistance varies by two or three orders of magnitude from the touch screen to the solar cell. At the same time, there is no unified test standard for device shape, electrode type, electrode contact method and measurement method. As there is no widely accepted standard for the methods to measure devices, the measurement results cannot be compared and the quality of graphene films cannot be comprehensively evaluated. Therefore, there is an urgent need to draft a standard for the measurement of carrier mobility and sheet resistance in graphene thin films. The document is developed to complete the fabrication and measurement of devices using cost- effective processes and equipment. Due to the high cost and low cost-performance ratio of photolithography processes and equipment, this document does not utilize photolithography processes and equipment. This method, based on the Hall effect, is recommended for graphene thin fi

Scope: This part of IEC 62607 establishes a standardized method to determine the key control characteristic (KCC) carrier mobility and sheet resistance for graphene thin films by Hall measurement. The carrier mobility is derived by the product of the Hall coefficient and the electric conductivity and the sheet resistance is derived by the product of the longitudinal resistance and the aspect ratio of a Hall device. The method is applicable for graphene thin film Hall devices with length and width greater than 100 micrometers.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62607-6-23-2025 PDF

IEC TS 62607-6-23-2025 PDF

$72.51 $145.02