Nanomanufacturing – Key control characteristics – Part 6-4: Graphene-based materials – Surface conductance: non-contact microwave resonant cavity method
Introduction: The microwave cavity test method for surface conductance is non-contact, fast, and accurate. It is well suited for standards development, research and development (R&D), and for quality control in the manufacturing of two-dimensional (2D) nano-carbon materials. These sheet-like or flake-like carbon forms can be assembled into atomically thin monolayer or multilayer graphene materials. They can be stacked, folded, crumpled, or pillared into a variety of nano- carbon architectures with the vertical dimension limited to a few tenths of a nanometre. Many of these 2D materials, and their derivatives, are new and exhibit extraordinary physical and electrical properties such as optical transparency, anisotropic heat diffusivity, and charge transport that are of significant interest to science, technology, and commercial applications [1]1, [2], [3]. Depending on particular morphologies, density of states, and structural perfection, the surface conductance of these materials can vary from1 S to about 10−5 S. Conventional direct current (DC) surface conductance measurement techniques require a complex test vehicle and interconnections for making electrical contacts to such materials, which affect and distort the measurement, thus, making it difficult to resolve the intrinsic properties of the material from the artifacts associated with the electrical contact formation. In comparison, the resonant cavity measurement method is non-contact, fast, and avoids the artifacts associated with t
Scope: This part of IEC 62607 establishes a standardized method to determine the key control characteristic surface conductance for films of graphene and graphene-based materials by the non-contact microwave resonant cavity method The non-contact microwave resonant cavity method monitors the microwave resonant frequency shifts and changes in the cavity’s quality factor during the insertion of the specimen into the microwave cavity, as a function of the specimen surface area. The empty cavity is an air-filled standard R100 rectangular waveguide operated at one of the resonant frequency modes, typically at 7,5 GHz [4]. The method is applicable for graphene materials which are synthesized by chemical vapour deposition (CVD) on metal substrates, epitaxial growth on silicon carbide (SiC), obtained from reduced graphene oxide (rGO), or mechanically exfoliated from graphite [5]. This measurement does not explicitly depend on the thickness of the nano-carbon layer. The thickness of the specimen does not need to be known, but it is assumed that the lateral dimensions are uniform over the specimen area. NOTE In some countries, the R100 standard waveguide is referenced as WR-90.
Contents:
- FOREWORD
- INTRODUCTION
- Scope