IEC TS 62607-6-5-2022 PDF

IEC TS 62607-6-5-2022 PDF

Nanomanufacturing-Key control characteristics-Part 6-5: Graphene-based materials-Contact resistance and sheet resistance: transmission line measurement

$100.88 $201.76 -50%
Product Code: IEC TS 62607-6-5
Stock In Stock
Edition: 1.0
Published: 12/2022
Number of Pages: 28
File Size: 1 file, 2 Bytes

Available Options

Product Description

Nanomanufacturing – Key control characteristics – Part 6-5: Graphene-based materials – Contact resistance and sheet resistance: transmission line measurement

Introduction: Technical Specifications for contact resistance and sheet resistance of two-dimensional materials provide a proper definition of contact resistance and sheet resistance measurement and an electrical characterization of two-dimensional materials. This document includes recommended conditions for a sample preparation and recommended method to measure contact resistance and sheet resistance of two-dimensional materials under test in the referenced background research results. Here, the transmission line measurement (TLM) is used which had been used to measure both contact resistance and sheet resistance for conventional bulk semiconductor devices including silicon devices. TLM devices are formed with various spacings between contacts from which contact resistance and sheet resistance are determined from voltage measured. Thickness of the atomic thin 2D materials cannot be defined clearly when the layers are ultrathin near monolayer, and therefore it is difficult to express the thickness-dependent electronic resistivities of the devices fabricated by using 2D materials. TLM is used conveniently to determine contact resistance and sheet resistance of 2D materials since it does not require thickness of tested materials to be included in the calculation procedure. The objectives of this document are to a) define the contact resistance and sheet resistance of two-dimensional materials; b) specify the methodology for contact resistance and sheet resistance measurements of two-dimensio

Scope: This part of IEC TS 62607 establishes a standardized method to determine the key control characteristics contact resistance, and sheet resistance for graphene-based materials and other two-dimensional materials by a transmission line measurement. The method uses test structures applied to the 2D material by photolithographic methods consisting of several metal electrodes with increasing spacing between the electrodes. By a measurement of the voltage drop between different pairs of electrodes, sheet resistance and contact resistance can be calculated. The method can be applied to any other two-dimensional materials which are subject to electrical metal contact on top of the materials. The method provides accurate and reproducible results, if the electrical contact formed between the two-dimensional material and the metal electrodes provides ohmic contact property.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62607-6-5-2022 PDF

IEC TS 62607-6-5-2022 PDF

$100.88 $201.76