Nanomanufacturing – Key control characteristics – Part 6-7: Graphene – Sheet resistance: van der Pauw method
Introduction: Graphene is a single layer of carbon atoms arranged in a honeycomb lattice. Graphene has shown many outstanding properties, among which is a high electrical conductivity. Nowadays graphene can be easily grown and transferred on large area (cm2 to even m2) and even roll-to- roll supports using chemical vapour deposition (CVD) techniques. This is already enabling its commercial applications in electrotechnical products. Electrical conductivity of graphene samples can depend on many factors: structural quality, contamination, coupling with the physical support used for a given application to name a few. On practical grounds, sheet resistance is a quantity which can be used as global measure of the local conductivity of a sample with finite geometrical dimensions. In order to check the reproducibility of the electrical properties of graphene, the sheet resistance is clearly a key control characteristic for this material. The van der Pauw method [1]1 allows the measurement of the sheet resistance of samples of arbitrary shape, with isotropic conductivity and uniform carrier density by performing a pair of four-terminal resistance measurements with electrical contacts placed at arbitrary positions on the sample's perimeter. The method is fast (it takes a few minutes) and easy to implement, since many commercial fixtures are available. The four-terminal resistance measurements required to apply the method allow to minimize the effect of the contact resistance that appears between gr
Scope: This part of IEC TS 62607 establishes a method to determine the key control characteristics sheet resistance RS [measured in ohm per square (Ω/sq)], by the van der Pauw method, vdP. The sheet resistance RS is derived by measurements of four-terminal electrical resistance performed on four electrical contacts placed on the boundary of the planar sample and calculated with a mathematical expression involving the two resistance measurements. The measurement range for RS of the graphene samples with the method described in this document goes from 10−2 Ω/sq to 104 Ω/sq. The method is applicable for CVD graphene provided it is transferred to quartz substrates or other insulating materials (quartz, SiO2 on Si), as well as graphene grown from silicon carbide. The method is complementary to the in-line four-point-probe method (4PP, IEC 62607-6-8) for what concerns the measurement of the sheet resistance and can be applied when it is possible to reliably place contacts on the sample boundary, avoiding the sample being scratched by the 4PP. The outcome of the van der Pauw method is independent of the contact position provided the sample is uniform, which is typically not true for graphene at this stage. This document considers the case of samples with non-strictly uniform conductivity distribution and suggests a way to consider the sample inhomogeneity as a component of the uncertainty on RS.
Contents:
- FOREWORD
- INTRODUCTION
- Scope