IEC TS 62876-2-1-2018 PDF

IEC TS 62876-2-1-2018 PDF

Nanotechnology-Reliability assessment-Part 2-1: Nano-enabled photovoltaic devices-Stability test

$132.41 $264.81 -50%
Product Code: IEC TS 62876-2-1
Stock In Stock
Edition: 1.0
Published: 08/2018
Number of Pages: 34
File Size: 1 file, 480 Bytes

Available Options

Product Description

Nanotechnology – Reliability assessment – Part 2-1: Nano-enabled photovoltaic devices – Stability test

Introduction: Nano-enabled photovoltaics (NePV) is a novel format of photovoltaic technology that can be manufactured in large-area, flexible, thin sheets through solution processing or vapour deposition. Many of the materials involved are nanomaterials and organic semiconductors. They improve the conversion of sunlight into free electrons and support the extraction of the electrons out of the device. Furthermore, nanomaterials are used as boundary layers and act as protective coatings to increase the stability of the PV device. NePV has the potential to provide low-cost renewable energy due to relatively inexpensive, high-throughput manufacturing and low material costs, as a result of the use of low-cost flexible polymeric substrates and packaging films [1]. In addition, NePV is expected to enable new products due to its light weight, flexibility, ability to adapt and tune colour appearance and good efficiency at low light levels, which is conducive to indoor use. Due to these properties NePV is attracting more attention from a variety of groups with a view to improving the efficiency and stability, which has resulted in significant efficiency gains through achievements in materials engineering and process optimization. Concerning stability, however, improvements have not been evident and have not been demonstrated, since standardized testing methods do not exist. In order to commercialize NePV, its stability must be addressed and means for properly comparing stability need to be develope

Scope: This part of IEC 62876, which is a Technical Specification, establishes a general stability testing programme to verify the stability of the performance of nanomaterials and nano- enabled photovoltaic devices (NePV) devices. These devices are used as subassemblies for the fabrication of photovoltaic modules through a combination with other components. This testing programme defines standardized degradation conditions, methodologies and data assessment for technologies. The results of these tests define a stability under standardized degradation conditions for quantitative evaluation of the stability of a new technology. The procedures outlined in this document were designed for NePV, but can be extended to serve as a guideline for other photovoltaic technologies as well. NOTE 1 The tests in this document are selected with outdoor use in mind, and as such represent isolated stress factors that devices will be exposed to in outdoor environments. For indoor environments, the stresses faced by the devices in operation are significantly less severe, and not all tests will be applicable. Despite this, the suggested tests provide a means of tracking stability improvements and can provide valuable data during device development. NOTE 2 The performance of devices will be evaluated before and after the application of the stress tests. The efficiency characterization methods for NePV have not been fully established at present. In the text, notes are therefore added regarding the efficiency characterization. The notes particularly address issues to be discussed in the future for applications such as indoor use, or devices with a slow response or uncommon spectral responses such as tandem cells. NOTE 3 The scope does not include photovoltaic modules, i.e. the final product. It is only intended to test the technology.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62876-2-1-2018 PDF

IEC TS 62876-2-1-2018 PDF

$132.41 $264.81