Microgrids – Part 2: Guidelines for operation
Introduction: Microgrids can serve different purposes depending on the primary objectives of their applications. They are usually seen as means to facilitate the management of grid contingency and the local optimization of energy supply by controlling distributed energy resources (DER). Microgrids also present a way to provide electricity supply in remote areas and to use clean and renewable energy as a systemic approach for rural electrification. IEC TS 62898 series is intended to provide with comprehensive guidelines and requirements for microgrid projects. IEC TS 62898-1 mainly covers the following issues: 1) determination of microgrid purposes and application; 2) preliminary study necessary for microgrid planning, including resource analysis, load forecast, DER planning and power system planning; 3) principles of microgrid technical requirements that should be specified during planning stage; 4) microgrid evaluation to select an optimal microgrid planning scheme. IEC TS 62898-2 mainly covers the following issues: a) response characteristic requirements of microgrids under different operation modes; b) the basic control strategies and methods under different operation modes; c) the requirements of electrical energy storage (EES), communication and monitoring under different operation modes; d) the principle of relay protection under different operation modes; e) basic requirements of synchronization and reclosing during mode transfer; f) principle for power quality, EMC, maintenance and
Scope: The purpose of this document is to provide guidelines for operation of microgrids. Microgrids considered in this document are alternating current (AC) electrical systems with loads and distributed energy resources (DER) at low or medium voltage level. This document does not cover direct current (DC) microgrids. Microgrids are classified into isolated microgrids and non-isolated microgrids. Isolated microgrids have no electrical connection to a larger electric power system and operate in island mode only. Non-isolated microgrids may act as controllable units to the electric power system and can operate in the following two modes: grid-connected mode; island mode. The 62898 series is intended to provide guidelines and the basic technical requirements to ensure the security, reliability and stability of microgrids. IEC TS 62898-2 applies to operation and control of microgrids, including: operation modes and mode transfer; energy management system (EMS) and control of microgrids; communication and monitoring procedures; electrical energy storage; protection principle covering: principle for non-isolated microgrid, isolated microgrid, anti- islanding, synchronization and reclosing, power quality; commissioning, maintenance and test. NOTE 1 Safety for personnel is outside the scope of this document, and such information is referred to in IEC TC 64 and TC 99 publications. NOTE 2 Local laws and regulations can overrule the requirements of this document. NOTE 3 The principles for main types of protections in microgrid, fault analysis for converter type and rotating machines type, protection type selection, general technical requirements, setting value principles and so forth are intended to be developed in IEC TS 62898-3-11.
Contents:
- FOREWORD
- INTRODUCTION
- Scope