Photovoltaics in buildings - Part 3: Determination methodology for the solar heat gain coefficient of building-integrated photovoltaic modules
Introduction: IEC 63092-1 and IEC 63092-2 describe general requirements for building-integrated photovoltaic (BIPV) modules and systems, respectively. This part of IEC 63092 describes specific requirements for the calorimetric determination of the solar heat gain coefficient (SHGC or g value) for various designs of BIPV modules and provides complementary information to IEC 63092-1. BIPV modules are often custom made and the design qualification is complicated. In particular, g-value measurements for construction components are made on test samples with dimensions which are different to those specified for PV modules in IEC test standards. It is important for manufacturers and users to use a simplified test method requiring a small number of test specimens that provides applicable results to a variety of BIPV modules consisting of identical components but varying in the effective cell area ratio. The test method consists of two successive steps: g-value evaluation for transparent test samples with the same glazing and encapsulant components as the BIPV modules, but without solar cells or interconnects, and g-value evaluation for BIPV modules with a standard size in the open circuit and maximum power point states. By using data for these samples, the g values for any effective PV cell area ratio can be obtained by interpolation, corresponding to the g values for BIPV modules with the same cell type and glazing configuration, but with different heights, widths and cell configurations. In the
Scope: This part of IEC 63092 is intended to provide a versatile method to determine the solar heat gain coefficient (SHGC or g value) of BIPV modules with a variety of designs. It addresses the calorimetric determination of the g value for BIPV modules by using the hot box method or the cooled plate method in accordance with ISO 19467 and ISO 19467-2. The method takes into account the effect on the g value of extracting photovoltaically generated electricity from the BIPV module in the maximum power point state. This document applies to BIPV modules as defined in IEC 63092-1 and specifically to BIPV modules with different effective cell area ratios but consisting of identical components such as cells, interconnects, encapsulation and front/back sheets. This evaluation method is applicable to all PV cell technologies and includes coloured BIPV modules. NOTE The solar heat gain coefficient is known by various names (SHGC, g value, solar factor, total solar energy transmittance, etc.) depending on the country and region. These terms are all used to describe the same property; small differences can be caused by different reference conditions (e.g. differences in the reference solar spectrum). In this document, the quantity is referred to as the g value.
Contents:
- FOREWORD
- INTRODUCTION
- Scope