Photovoltaic (PV) modules – Qualifying guidelines for increased hail resistance
Introduction: The hail test (MQT 17) of IEC 61215-2:2021, 4.17 examines PV modules for minimum hail resistance by using spherical ice balls of a minimum diameter of 25 mm, or optionally larger. The requirements after the test, as specified in IEC 61215-2, are: a) no intermittent open-circuit fault detected during the test, b) no evidence of major visual defects, c) wet leakage current meeting the same requirements as for the initial measurements and the power loss requirement of (Gate No. 2) IEC 61215-1:2021, 7.2.3. The hail test (MQT 17) may cause visible damage detectable by MQT 01 as well as invisible internal damage not detectable by MQT 01. Such invisible damage may also only be detected by Gate No. 2 (power loss measurement after stress tests) if the damage is relatively large. The IEC 61215 series [1]1 lays down requirements for the design qualification and type approval of terrestrial photovoltaic modules suitable for long-term operation in open-air climates. It is however not written with the intent to detect medium to long term performance losses caused by hail to internal parts not visible to the naked eye. Such internal damages may be micro-cracks of cells which over time can be propagated by other mechanical and thermo-mechanical environmental stresses not addressed by the test flow of IEC 61215-1:2021, Figure 2. The hail test (MQT 17) of IEC 61215-2:2021, 4.17 is sufficient for the generic design qualification and type approval for applications and environments where PV modul
Scope: This document defines additional testing requirements for modules deployed under applications or in environments where PV modules are likely to be exposed to the impact of hailstones leading to higher stress beyond the scope of the IEC 61215 series. The current safety standards of the IEC 61730 series [4] and design qualification and type approval standards of the IEC 61215 series specify tests for the ability of PV modules to withstand a defined hail impact. The requirements therein are the minimum for market entrance and are not written to propagate potential cell damage caused by the hail impact by subsequent mechanical and thermo-mechanical tests simulating the environmental stress that modules will potentially be exposed to after hailstorms. In this document modules are initially exposed to 200 h of damp heat to account for some level of humidity and heat before the first hail exposure. After that they are exposed to hail stresses and then to the selected thermo-mechanical stress tests of sequence C of IEC 61215-1:2021, Figure 2. The power loss from these modules is then compared to reference modules that have been through the same stress tests except the hail stress. Comparison of electroluminescence images and performance of both reference modules and modules exposed to hail stress provides additional insight regarding hail resistance and susceptibility. This document aims to assist in the selection of modules for deployment in specific regions that have a higher risk of hail damage and to provide tools for improving module design.
Contents:
- FOREWORD
- INTRODUCTION
- Scope