IEEE 115-2019 PDF

IEEE 115-2019 PDF

IEEE Guide for Test Procedures for Synchronous Machines Including Acceptance and Performance Testing and Parameter Determination for Dynamic Analysis

$112.50 $225.00 -50%
isbn 9781504463478
Product Code: IEEE 115
Stock In Stock
Published: 03/27/2020
Number of Pages: 232
File Size: 1 file, 3.6 MB

Available Options

Product Description

IEEE Guide for Test Procedures for Synchronous Machines Including Acceptance and Performance Testing and Parameter Determination for Dynamic Analysis

Introduction: This introduction is not part of IEEE Std 115-2019, IEEE Guide for Test Procedures for Synchronous Machines Including Acceptance and Performance Testing and Parameter Determination for Dynamic Analysis IEEE Std 115-2019 incorporates and updates the contents of the 2009 edition. The first AIEE “Test Code” for Synchronous Machines (#503) was issued in 1945 and formed the basis for the subsequent IEEE Std 115, which was first published in 1965. The Generator Subcommittee’s Working Group (WG) #7, which produced this guide, was formed in July 2015 at the IEEE PES General Meeting, and the Project Authorization Request (PAR) was approved by the IEEE SA Standards Board in December 2015. This PAR included a proposal by the WG to update the entire document to reflect the state-of-the-art practices and technology. All corrections sent by users of the standard to IEEE SA were reviewed by the WG and implemented as needed. The WG decided to keep the format and titles of the guide the same as in the previous edition. During editorial review, it was recommended that the working group discontinue the title in two parts and make one title including the previous separate titles.

Contents:

  • 1.1 Scope
  • 1.2 Organization of the guide
  • 1.3 Miscellaneous notes
  • 1.4 Instrumentation
  • 4.1 Insulation resistance
  • 4.2 Dielectric and partial discharge tests
  • 4.3 Resistance measurements
  • 4.4 Tests for short-circuited field turns
  • 4.5 Polarity test for field poles
  • 4.6 Shaft current and bearing insulation
  • 4.7 Phase sequence
  • 4.8 Stator terminal voltage—waveform deviation and distortion factors
  • 4.9 Overspeed tests
  • 4.10 Line-charging capacity
  • 4.11 Acoustic noise
  • 4.12 Vibration testing
  • 5.1 Saturation curves
  • 5.2 General considerations in segregated loss measurements
  • 5.3 Methods to measure losses
  • 5.4 Efficiency
  • 6.1 General
  • 6.2 Test methods
  • 6.3 Load excitation calculation methods for specified machine terminal conditions
  • 6.4 Excitation calculation methods used in stability computer programs
  • 7.1 General
  • 7.2 Methods of loading
  • 7.3 Duration of test
  • 7.4 Methods to measure temperature
  • 7.5 Preparation for test
  • 7.6 Determination of coolant temperature

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEEE 115-2019 PDF

IEEE 115-2019 PDF

$112.50 $225.00