IEEE 117-2015 PDF

IEEE 117-2015 PDF

IEEE Standard Test Procedure for Thermal Evaluation of Systems of Insulating Materials for Random-Wound AC Electric Machinery

$35.50 $71.00 -50%
isbn 9781504406888
Product Code: IEEE 117
Stock In Stock
Published: 05/06/2016
Number of Pages: 34
File Size: 1 file, 4.2 MB

Available Options

Product Description

IEEE Standard Test Procedure for Thermal Evaluation of Systems of Insulating Materials for Random-Wound AC Electric Machinery

Introduction: This introduction is not part of IEEE Std 117™-2015, IEEE Standard Test Procedure for Thermal Evaluation of Systems of Insulating Materials for Random-Wound AC Electric Machinery. This standard is provides an evaluation of the thermal capability of an unsealed random-wound insulation sys- tem. Other aging factors—electrical, mechanical, and environmental—are also known to be important. Test procedures for evaluating those factors, both individually and in combination with each other, will be pursued by other working groups. This standard was updated in 2015, with specific limitations noted here: Consideration of uprating for usage to 1000 V was discussed, but not implemented in the 2015 version. This was due to concerns about uprating without adequate test data. Publications and data collection of testing up to 1000 V should be completed prior to placing it into an IEEE standard. The use of a condensation chamber is listed herein. There is a round-robin study pending that will in- vestigate the alternate use of a humidity chamber for testing. At present this standard remains with the wording of condensation chamber. Comments on, and suggestions for the improvement of, this standard are welcome, and should be sent to the IEEE Standards Board (see Participants). Acknowledgements The committee would like to gratefully acknowledge ELTEK International Laboratories, Shermco Industries, and Von Roll USA for their contributions of photos and images for this standard.

Contents:

  • 1.1 Scope
  • 1.2 Purpose
  • 1.3 General conditions
  • 1.4 Methods of evaluation
  • 3.1 Defi nitions
  • 3.2 Abbreviations and acronyms
  • 4.1 Background information
  • 4.2 Methods of evaluation
  • 5.1 Insulation test specimens
  • 5.2 Test exposures for motorette testing
  • 5.3 Voltage checks for motorette testing
  • 5.4 Failure criteria for motorette testing
  • 6.1 Test procedure for motors
  • 6.2 Motor models
  • 6.3 Test exposures for motor testing
  • 6.4 Operating cycle sequence testing
  • 7.1 Data
  • 7.2 Analysis
  • 7.3 Comparison
  • 7.4 Extrapolation
  • 7.5 Nonlinear or dissimilar curves

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEEE 117-2015 PDF

IEEE 117-2015 PDF

$35.50 $71.00