IEEE Standard for Ubiquitous Green Community Control Network: Control and Management
Introduction: This introduction is not part of IEEE Std 1888.1-2013, IEEE Standard for Ubiquitous Green Community Control Network: Control and Management. In an IEEE 1888 network, there are components [such as an application (APP), a gateway (GW) and storage, etc.] and sensors/actuators. GWs and sensors/actuators are the most popular facilities used in Ubiquitous Green Community Control Networks (UGCCNets). Sensors/actuators are data terminals that “generate” physical data or “accept” command data. GWs are used to relay data between sensors/actuators and other components, and data translation may be made during the transmission. GWs could be provided by different vendors or suppliers with different functions; therefore, they need to be managed to operate collaboratively. In this case, a consistent protocol, which is the essential task of this standard, is required. This standard is based on IEEE Std 1888-2011 protocols, enhancing the management and control functionality of the network by extending the interfaces, protocols, and message formats, and focuses on the GW-related workflows for access, control, configuration, registration, running status, event handling, etc. Three aspects are included in this specification: a) Specifying system architecture to manage and control GWs and the connected sensors/actuators b) Providing methods to monitor GWs c) Describing the communication processes that facilitate the operation abilities In order to achieve effective network operation management, th
Contents:
- 1.1 Scope
- 1.2 Purpose
- 3.1 Definitions
- 3.2 Acronyms and abbreviations
- 4.1 General
- 4.2 System architecture
- 4.3 General workflow to manage sensors and actuators
- 5.1 General
- 5.2 Framework
- 5.3 Typical MCU communication sequences
- 6.1 General
- 6.2 Framework
- 6.3 Access control
- 6.4 Event handling
- 7.1 Overview
- 7.2 Setting the configuration and running status of the GW
- 7.3 Getting the configuration and running status of the GW
- 7.4 Sending control command data to actuators
- 7.5 Reading the real-time data of sensors
- 8.1 Protocol definition
- 8.2 Data structure
- 9.1 General
- 9.2 Data structure
- 9.3 Redefinition of header class
- 9.4 Control class