IEEE 2862-2020 PDF

IEEE 2862-2020 PDF

IEEE Recommended Practice for Partial Discharge Measurements under AC Voltage with VHF/UHF Sensors during Routine Tests on Factory and Pre-Molded Joints of HVDC Extruded Cable Systems up to 800 kV

$31.50 $63.00 -50%
isbn 9781504472579
Product Code: IEEE 2862
Stock In Stock
Published: 03/08/2021
Number of Pages: 29
File Size: 1 file, 4.3 MB

Available Options

Product Description

IEEE Recommended Practice for Partial Discharge Measurements under AC Voltage with VHF/UHF Sensors during Routine Tests on Factory and Pre-Molded Joints of HVDC Extruded Cable Systems up to 800 kV

Introduction: This introduction is not part of IEEE Std 2862-2020, IEEE Recommended Practice for Partial Discharge Measurements under AC Voltage with VHF/UHF Sensors during Routine Tests on Factory and Pre-Molded Joints of HVDC Extruded Cable Systems up to 800 kV. High-voltage direct-current (HVDC) cable systems with extruded insulation are becoming a more appealing option compared with Mass Impregnated Non-Draining (MIND) HVDC cable systems (see [B15],[B12])1, but still have issues to be addressed. One is the development of long-lasting and reliable accessories, namely joints and terminations. In fact, test and service experience shows that joints, whose number is huge in long HVDC links, are the components that mostly affect the reliability of the whole cable system, but so far only a few tests exist on joints for HVDC extruded cable systems and there is a lack of standardization (see [B13]). Aiming to fill this gap, the IEEE DEIS HVDC Cable Systems Technical Committee followed the suggestions by CIGRÉ Technical Brochure (TB) 496:20122 and [B18], thereby preparing two position papers published in 2019 (see [B13] and [B14]). In [B13] it is shown that today: a) Among prospective methods to characterize joints using new qualification and routine tests the electrical techniques identified are: 1) Space charge (SC) measurements, still very challenging when considering full-size accessories. 2) Partial discharge (PD) measurements, fostered in CIGRÉ TB 496:2012 and [B18]. b) Routine tests are t

Contents:

  • 1.1 Scope��������������������������������������������������������������������������������������������������������������������������������������������������11
  • 1.2 Word usage�����������������������������������������������������������������������������������������������������������������������������������������11
  • 3.1 Definitions������������������������������������������������������������������������������������������������������������������������������������������12
  • 3.2 Acronyms and abbreviations��������������������������������������������������������������������������������������������������������������14
  • 4.1 Overview��������������������������������������������������������������������������������������������������������������������������������������������14
  • 4.2 Performance check�����������������������������������������������������������������������������������������������������������������������������14
  • 4.3 Test set-up arrangement����������������������������������������������������������������������������������������������������������������������15
  • 4.4 Measurement procedure���������������������������������������������������������������������������������������������������������������������16

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEEE 2862-2020 PDF

IEEE 2862-2020 PDF

$31.50 $63.00