IEEE Recommended Practice for Equipment Grounding and Bonding in Industrial and Commercial Power Systems
Introduction: This introduction is not part of IEEE Std 3003.2™-2014, IEEE Recommended Practice for Equipment Grounding and Bonding in Industrial and Commercial Power Systems. IEEE 3000 Standards Collection® This recommended practice was developed by the Technical Books Coordinating Committee of the Industrial and Commercial Power Systems Department of the Industry Applications Society as part of a project to repackage the popular IEEE Color Books®. The goal of this project is to speed up the revision process, eliminate duplicate material, and facilitate use of modern publishing and distribution technologies. When this project is completed, the technical material in the thirteen IEEE Color Books will be included in a series of new standards—the most significant of which will be a new standard, IEEE Std 3000™, IEEE Recommended Practice for the Engineering of Industrial and Commercial Power Systems. The new standard will cover the fundamentals of planning, design, analysis, construction, installation, startup, operation, and maintenance of electrical systems in industrial and commercial facilities. Approximately 60 additional dot standards, organized into the following categories, will provide in-depth treatment of many of the topics introduced by IEEE Std 3000™: Power Systems Design (3001 series) Power Systems Analysis (3002 series) Power Systems Grounding and Bonding (3003 series) Protection and Coordination (3004 series) Emergency, Standby Power, and Energy Management Systems (3005 series
Contents:
- 1.1 Scope
- 1.2 General
- 1.3 Covered—equipment grounding and bonding
- 1.4 Not covered—system grounding
- 1.5 General
- 1.6 Objectives
- 1.7 Electric shock exposure
- 1.8 Thermal capability
- 1.9 Overcurrent protection operation
- 3.1 Grounding and bonding terminology
- 3.2 Acronyms not defined in definitions section
- 3.3 Terminology pictorial guide
- 4.1 Cabling of conductors
- 4.2 Enclosing metal shell
- 4.3 Electromagnetic interference suppression
- 4.4 Bonding of metal sleeves enclosing a protective conductor
- 4.5 Protective connections associated with steep wave front voltage protection equipment
- 4.6 Connection to earth
- 6.1 General
- 6.2 Design of paths for power frequency ground-fault current flow
- 6.3 Design of earthing connections
- 6.4 Surge voltage protective equipment
- 6.5 Control of surface voltage gradient
- 6.6 Voltage gradients external to, but adjacent to, the boundary fence
- 8.1 General
- 8.2 Service equipment
- 8.3 Interior electric circuits
- 8.4 Thermal withstand
- 9.1 Switching centers
- 9.2 Unit substations