IEEE 4-2013 PDF

IEEE 4-2013 PDF

IEEE Standard for High-Voltage Testing Techniques

$137.00 $274.00 -50%
isbn 9780738182582
Product Code: IEEE 4
Stock In Stock
Published: 05/10/2013
Number of Pages: 213
File Size: 1 file, 2.2 MB

Available Options

Product Description

IEEE Standard for High-Voltage Testing Techniques

Introduction: This introduction is not part of IEEE Std 4-2013, IEEE Standard for High-Voltage Testing Techniques. The current revision of this standard is the eighth edition of this document as a separate standard. The subject had been addressed in the earliest standardization report of the American Institute of Electrical Engineers (AIEE) in 1889 and had been substantially elaborated upon in the subsequent reports issued from 1902 to 1933. When it was decided, in 1922, to reorganize the AIEE’s standards into separate sections, the measurement of test voltages became one of the first subjects to be designated for a separate publication. The first edition was published in 1928. This standard establishes standard methods and basic techniques for high-voltage testing. The standard is applicable to all types of apparatus for alternating voltages, direct voltages, lightning impulse voltages, switching impulse voltages, and impulse currents. The following standards have been used to prepare this document: IEC 60052, Recommendations for voltage measurement by means of standard air gaps. IEC 60060-1, High-voltage test techniques—Part 1: General definitions and test requirements. IEC 60060-2, High-voltage test techniques—Part 2: Measuring systems. IEC 60060-3, High-voltage test techniques—Part 3: Definitions and requirements for on-site testing. IEC 60270, Partial discharge measurements. IEC 60507, Artificial pollution tests on high-voltage insulators to be used on a.c. systems. IEC 61083-1, Instr

Contents:

  • 1.1 Scope
  • 1.2 Purpose
  • 1.3 Application
  • 5.1 Normal environmental conditions
  • 5.2 Arrangement of the test object
  • 5.3 Grounding requirements for high-voltage tests
  • 5.4 Use of properly dimensioned interconnections and electrodes
  • 5.5 Susceptibility to noise: instrumentation shielding
  • 5.6 Classification of measuring systems
  • 5.7 Procedures for qualification and use of measuring systems
  • 6.1 Terms used to characterize alternating voltage tests and measurements
  • 6.2 Source requirements
  • 6.3 Measuring system requirements for approved measuring systems
  • 6.4 Test procedures
  • 6.5 Type tests, acceptance tests, performance tests, and performance checks for alternating voltage
  • 6.6 Additional information on alternating voltage test and measurement techniques
  • 7.1 Terms used to characterize direct voltage tests and measurements
  • 7.2 Source requirements
  • 7.3 Measuring system requirements for approved measuring systems
  • 7.4 Test procedures
  • 7.5 Type tests, acceptance tests, performance tests, and performance checks for direct voltage measuring
  • 7.6 Additional information on direct voltage test and measurement techniques
  • 8.1 Terms used to characterize impulse voltage tests and measurements
  • 8.2 Source requirements
  • 8.3 Measuring system requirements for approved measuring systems
  • 8.4 Test procedures
  • 8.5 Type tests, acceptance tests, performance tests, and performance checks for impulse voltage
  • 8.6 Additional information on impulse voltage test and measurement techniques
  • 8.7 Reference voltage divider
  • 9.1 Terms used to characterize impulse currents

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEEE 4-2013 PDF

IEEE 4-2013 PDF

$137.00 $274.00