IEEE Standard for Test Procedures and Requirements for Alternating-Current Cable Terminations Used on Shielded Cables Having Laminated Insulation Rated 2.5 kV through 765 kV or Extruded Insulation Rated 2.5 kV through 500 kV
Introduction: This introduction is not part of IEEE Std 48™-2020, IEEE Standard for Test Procedures and Requirements for Alternating-Current Cable Terminations Used on Shielded Cables Having Laminated Insulation Rated 2.5 kV through 765 kV or Extruded Insulation Rated 2.5 kV through 500 kV. This standard supersedes IEEE Std 48-2009, IEEE Standard Test Procedures and Requirements for Alternating-Current Cable Terminations 2.5 kV through 765 kV. This standard has been harmonized with IEEE Std 404™-2012 [B22]1 to allow for simultaneous testing of terminations and joints. Definitions specific to this standard are contained in Clause 3 and Annex B. All other definitions and terminology used herein can be found in IEEE Standards Dictionary Online.2 In Clause 3 several definitions have been added: basic lightning impulse insulation level (BIL), basic switching impulse insulation level (BSL), family of terminations, and insulation class. Clause 4, Service conditions, has been updated with an expanded temperature range. Clause 5, Rating, has been updated and simplified. Clause 6, Product markings, has been substantially rewritten. DC voltage design tests have been removed from 7.1. Family of terminations and range of approval requirements have been added to 7.1. In Table 1, Table 2, and Table 3, dc voltage tests have been eliminated. In Table 1, Note 13 has been added with respect to requirements for tubular terminations intended for application only within switchgear. Table 5 has been replaced wit
Contents:
- 1.1 Scope��������������������������������������������������������������������������������������������������������������������������������������������������10
- 1.2 Word usage�����������������������������������������������������������������������������������������������������������������������������������������10
- 4.1 Usual service conditions���������������������������������������������������������������������������������������������������������������������12
- 4.2 Unusual service conditions�����������������������������������������������������������������������������������������������������������������13
- 7.1 Type tests��������������������������������������������������������������������������������������������������������������������������������������������15
- 7.2 Routine tests���������������������������������������������������������������������������������������������������������������������������������������17
- 8.1 Preparation of test specimen���������������������������������������������������������������������������������������������������������������18
- 8.2 Standard test conditions����������������������������������������������������������������������������������������������������������������������18
- 8.3 Correction factors�������������������������������������������������������������������������������������������������������������������������������26
- 8.4 Type tests��������������������������������������������������������������������������������������������������������������������������������������������27
- 8.5 Routine tests���������������������������������������������������������������������������������������������������������������������������������������40
- 8.6 Electrical tests after installation����������������������������������������������������������������������������������������������������������41
- 10.1 Solar radiation (ultraviolet [UV] light) testing���������������������������������������������������������������������������������41
- 10.2 Accelerated contamination testing����������������������������������������������������������������������������������������������������42
- 10.3 Multiple stress testing�����������������������������������������������������������������������������������������������������������������������42