IEEE C57.130-2015 PDF

IEEE C57.130-2015 PDF

IEEE Guide for the Use of Dissolved Gas Analysis Applied to Factory Temperature Rise Tests for the Evaluation of Mineral Oil-Immersed Transformers and Reactors

$30.00 $60.00 -50%
isbn 9781504406864
Product Code: IEEE C57.130
Stock In Stock
Published: 02/19/2016
Number of Pages: 17
File Size: 1 file, 1.5 MB

Available Options

Product Description

IEEE Guide for the Use of Dissolved Gas Analysis Applied to Factory Temperature Rise Tests for the Evaluation of Mineral Oil-Immersed Transformers and Reactors

Introduction: This introduction is not part of IEEE Std C57.130™-2015, IEEE Guide for the Use of Dissolved Gas Analysis Applied to Factory Temperature Rise Tests for the Evaluation of Mineral Oil-Immersed Transformers and Reactors. The evaluation of gases generated in oil-immersed transformers and reactors during factory temperature rise tests is a useful method of detecting thermal problems. These thermal problems may be due to abnormal leakage fl ux heating in the windings and leads, the magnetic circuit, or in structural elements. They may also be caused by inadequate heat dissipation or poor oil circulation within the core or windings, imperfect connections or contacts, excessive paper insulation, or clogged or inadequate cooling ducts. This guide was written with the understanding that, as additional experience is gained; periodic reviews will be made to ensure that recommendations in this guide continue to be based on the most up-to- date information. The factory temperature rise test (formerly known as the heat run test) is performed in accor- dance with IEEE Std C57.12.90™ to determine whether the temperature rises of the windings, oil, and other components meet design values. When testing power transformers, it is normally performed by the short circuit method; therefore, the losses and corresponding heating produced by core fl ux are minimal and the superposition of core and leakage fl ux during actual loading are not accurately represented by this test. On the other hand, during mu

Contents:

  • 1.1 Scope
  • 1.2 Purpose
  • 6.1 Oil sampling before temperature rise—Sample 1
  • 6.2 Oil sampling at end of temperature rise test—Sample 2
  • 6.3 Intermediate sampling
  • 7.1 Determination of generated component concentration increases
  • 7.2 Determination of average generation rates
  • 7.3 Evaluation of gas generation rates

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEEE C57.130-2015 PDF

IEEE C57.130-2015 PDF

$30.00 $60.00