IEEE C62.34-2017 PDF

IEEE C62.34-2017 PDF

IEEE Standard for Test Methods and Performance of Low-Voltage (1000 V rms or Less) Surge Protective Devices Used on Secondary Distribution Systems (Between the Transformer Low-Voltage Terminals and the Line Side of the Service Equipment)

$35.50 $71.00 -50%
isbn 9781504443258
Product Code: IEEE C62.34
Stock In Stock
Published: 10/27/2017
Number of Pages: 40
File Size: 1 file, 1.7 MB

Available Options

Product Description

IEEE Standard for Test Methods and Performance of Low-Voltage (1000 V rms or Less) Surge Protective Devices Used on Secondary Distribution Systems (Between the Transformer Low-Voltage Terminals and the Line Side of the Service Equipment)

Introduction: This introduction is not part of IEEE Std C62.34™-2017, IEEE Standard for Test Methods and Performance of Low-Voltage (1000 V rms or Less) Surge Protective Devices Used on Secondary Distribution Systems (Between the Transformer Low-Voltage Terminals and the Line Side of the Service Equipment). Secondary arresters have been used since 1940 to protect the secondary winding of distribution transformers, kilowatt-hour meters, service entrance equipment, and power equipment loads downstream from breakdown of insulation during lightning strikes and switching surges. Performance criteria for secondary arresters were included in standards for performance of high-voltage arresters in IEEE Std C62.1™-1989 and IEEE Std C62.11™-1993. However, IEEE Std C62.1-1989 is no longer in publication and IEEE Std C62.11-1993 has been updated and secondary arresters dropped from its scope. With the proliferation of electronic equipment installed inside buildings, the emphasis has shifted away from protection of insulation of transformer windings and wiring to protection of vulnerable downstream electronic equipment. Due to increased sensitivity of downstream equipment to surges, the requirements for secondary arresters have necessarily become more stringent. The standards developers have attempted, as far as reasonable and possible, to harmonize with relevant domestic and international standards.

Contents:

  • 4.1 Usual service conditions���������������������������������������������������������������������������������������������������������������������12
  • 4.2 Unusual service conditions�����������������������������������������������������������������������������������������������������������������13
  • 5.1 Identification��������������������������������������������������������������������������������������������������������������������������������������14
  • 5.2 Typical values�������������������������������������������������������������������������������������������������������������������������������������14
  • 7.1 General�����������������������������������������������������������������������������������������������������������������������������������������������15
  • 7.2 Laboratory conditions ������������������������������������������������������������������������������������������������������������������������17
  • 7.3 Surge parameters �������������������������������������������������������������������������������������������������������������������������������17
  • 7.4 Determination of voltage protection level������������������������������������������������������������������������������������������17
  • 7.5 Maximum discharge current (Imax) (Ip)������������������������������������������������������������������������������������������������18
  • 7.6 Nominal discharge current test�����������������������������������������������������������������������������������������������������������19
  • 7.7 Loss of neutral test������������������������������������������������������������������������������������������������������������������������������20
  • 7.8 Through-fault current withstand test (two-port SPDs only)����������������������������������������������������������������22
  • 7.9 Short circuit current rating (SCCR) test����������������������������������������������������������������������������������������������23
  • 7.10 Low and intermediate fault current withstand tests��������������������������������������������������������������������������30
  • 7.11 Rated temporary overvoltage (TOV) withstand verification�������������������������������������������������������������31
  • 7.12 Temperature rise (two-port SPDs only)��������������������������������������������������������������������������������������������33
  • 8.1 Overview��������������������������������������������������������������������������������������������������������������������������������������������35
  • 8.2 Voltage protection level����������������������������������������������������������������������������������������������������������������������35
  • 8.3 Power-frequency voltage test�������������������������������������������������������������������������������������������������������������35

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEEE C62.34-2017 PDF

IEEE C62.34-2017 PDF

$35.50 $71.00