IEEE C62.36-2016 PDF

IEEE C62.36-2016 PDF

IEEE Standard Test Methods for Surge Protectors and Protective Circuits Used in Information and Communications Technology (ICT) Circuits, and Smart Grid Data Circuits

$85.50 $171.00 -50%
isbn 9781504435789
Product Code: IEEE C62.36
Stock In Stock
Published: 11/02/2016
Number of Pages: 146
File Size: 1 file, 4.5 MB

Available Options

Product Description

IEEE Standard Test Methods for Surge Protectors and Protective Circuits Used in Information and Communications Technology (ICT) Circuits, and Smart Grid Data Circuits

Introduction: This introduction is not part of IEEE Std C62.36-2016, IEEE Standard Test Methods for Surge Protectors and Protective Circuits Used in Information and Communications Technology (ICT) Circuits, and Smart Grid Data Circuits. This standard applies to surge protectors for application on multiconductor balanced or unbalanced information and communications technology (ICT) circuits and smart grid data circuits. These surge protectors are designed to limit voltage surges, current surges, or both. The surge protectors covered are generally multiple-component series or parallel combinations of linear or nonlinear elements, packaged or organized for the purpose of limiting voltage, current, or both. This standard describes the methods of testing and criteria (where appropriate) for the characteristics and ratings of surge protectors used in ICT circuits and smart grid data circuits. This standard is not intended to cover packaged single gas tube, air gap, varistor, or avalanche junction surge-protective components (SPCs), which are covered by IEEE Std C62.31™ [B20], IEEE Std C62.32™ [B21], IEEE Std C62.33™ [B22], and IEEE Std C62.35™ [B23], respectively. Specifically excluded from this standard are test methods for low-voltage power circuit applications. For protection of wire-line communication facilities under the specialized conditions found at power stations, consult IEEE Std 487™ [B16].1, 2 1 The IEEE standards or products referred to in this introduction are trademarks owned by T

Contents:

  • 3.1 Definitions
  • 3.2 Acronyms and abbreviations
  • 4.1 Normal service conditions
  • 4.2 Unusual service conditions
  • 4.3 Radiation
  • 6.1 Standard design test criteria
  • 6.2 Statistical procedures
  • 6.3 Test conditions
  • 6.4 Test measurements
  • 7.1 General
  • 7.2 DC series resistance
  • 7.3 Capacitance
  • 7.4 Inductance
  • 7.5 Insulation resistance (IR) test
  • 7.6 Standby current test
  • 7.7 DC ringing current
  • 7.8 Distortion
  • 7.9 Transmission properties: insertion loss, return loss, phase shift
  • 7.10 Longitudinal conversion transfer loss (LCTL)
  • 7.11 Voltage reset [electronic current limiters (ECLs)]
  • 7.12 Impulse reset
  • 7.13 Transition current test for thermally activated components
  • 7.14 Time-to-trip test for thermally activated components
  • 7.15 Transverse surge generation
  • 7.16 DC-limiting voltage
  • 7.17 Impulse-limiting voltage
  • 7.18 In-line surge protector: protected port surge current let-through
  • 7.19 In-line surge protector: surge series resistance
  • 7.20 In-line surge protector: protected port ground potential rise (GPR)
  • 7.21 In-line surge protector: protected port ground lead inductive voltage spike

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEEE C62.36-2016 PDF

IEEE C62.36-2016 PDF

$85.50 $171.00