IEEE Guide for Motor-Operated Valve (MOV) Motor Application, Protection, Control, and Testing in Nuclear Power-Generating Stations
Introduction: This introduction is not part of IEEE Std 1290-2015, IEEE Guide for Motor-Operated Valve (MOV) Motor Application, Protection, Control, and Testing in Nuclear Power-Generating Stations. Motor-operated valves (MOVs) have historically presented both electrical and mechanical problems to the engineering community. Since a complete evaluation of MOV applications requires both electrical and mechanical disciplines, no one existing document covers MOVs in a comprehensive manner. As a result, MOV applications are evaluated using a wide array of existing standards and other documents. Thus, it is difficult to assemble all the supporting material to address all issues relating to MOVs and valve actuator motors (VAMs). This guide provides references to other published documents as applicable. This guide presents issues and suggestions for consideration in the application, protection, control, and testing of VAMs. It specifically attempts to cover topics not found in existing IEEE, or other easily accessible, documents. This guidance is an accumulation of recommendations and suggested solutions to problems based on experience. The reader is cautioned to use this guide in conjunction with applicable IEEE documents and new solutions to VAM problems that are continually evolving. Due to the dynamic nature of issues concerning MOVs, this document cannot be all-inclusive, and the user should search for information and solutions beyond this document. Limit and torque switch settings have also
Contents:
- 1.1 Scope
- 1.2 Purpose
- 3.1 Definitions
- 3.2 Acronyms and abbreviations
- 4.1 Thermal considerations
- 4.2 Voltage considerations
- 4.3 Motor torque
- 5.1 Thermal overload (TOL) relays
- 5.2 Fuses
- 5.3 Thermal contacts
- 5.4 Resistance temperature detector (RTD)—resistors
- 5.5 Molded case circuit breakers
- 5.6 DC VAM surge protection
- 6.1 Thermal overloads (TOLs)
- 6.2 Limit/torque switches
- 6.3 Valve control
- 6.4 Valve position indication
- 6.5 Alarms
- 6.6 Motor contactor
- 6.7 Interlocks
- 6.8 Hardware and material
- 6.9 Valve antihammering
- 6.10 Other considerations
- 6.11 Example
- 7.1 Common tests
- 7.2 Additional condition tests and inspections